point to point and multipoint
There are two types of Network Config, they are peer to peer or Client based.
coaxial cable and twisted pair cable. coaxial cable is the most widely used type of transmission line.
Types of UPS1. Standby UPSStandby UPS is then used. When the power supply shuts down. Then it supplies the consumed power to the computer when the power is off. In which the computer's data is safe.2. Line Interactive UPSDesigning a Line Interactive UPS is similar to a standby UPS. It is a combination of both UPS online and offline. This UPS is used for small businesses. And at the same time it controls the electrical effect of the UPS output.3. Standby Online HybridStandby on-line hybrid is a topology used in UPS under 10 kva. Which is switched on from battery to standby converter. The battery charger is much smaller than it is in Stand by UPS
- TheVLANs may be named.- The network administrator may create the VLANs in either global configuration mode or VLAN database mode.
The system network configuration refers to assigning a particular IP address by a network configuration window. The configuration window is usually invoked by selecting the network configuration sub menu from the setup command.
There are two types of Network Config, they are peer to peer or Client based.
There are two types of Network Config, they are peer to peer or Client based.
the types of network configuration is.. removing skills..
A symmetrical configuration
A symmetrical configuration
AMI and B8ZS
Dot-matrix printers and Line printers.
Bar graphs and line graphs.
i dont no
It's a transversal! Minimum induction will occur between the transmission lines using this configuration.
The two types of energy that make up mechanical energy are kinetic energy, which is the energy of motion, and potential energy, which is the stored energy due to position or configuration.
There are two main types of piano - upright, in which the strings are set vertically, and grand, in which the strings are set horizontally.