The CPU board is bad an needs to be repaired by a circuit board repair company. www.plrelectronics.com for example
The CPU Software has corrupted, get a EX.sys disk from Tajima or find the one that came with the machine and Initialize the CPU from the Floppy Drive built into the machine.
Very Rarely the CPU is actually faulty, unless you are very rich ... $3000 rich.
Regards,
Masis.com
How to get installation files for clear error code 3d6 Tajima model TFHX
Check with http://www.PLRElectronics.com or http://www.madpunch.com It means that your X or Y driver (boards) are bad....
The manual said to check the belt and sure enough it was broken in half. Unscrew the panel on the left hand side of the machine, where you put the allen wrench in to manually turn the needles up and down. The belt is right there. $110.00 to replace.
BEST ANSWER : A translator which generates code for a virtual stack machine.
3701
High-level language (HLL) is a term that applies to any computer language that applies a level of abstraction such that there is little or no direct relationship between the code being written and the machine code that is compiled from that code. Java is an HLL with one of the highest levels of abstraction. Its code compiles to byte code rather than machine code, which is then interpreted by the Java virtual machine (JVM). This makes it highly portable as there are few systems that don't have a JVM implementation. However, there's very little access to the underlying architecture as code is written to suit the JVM, a virtual non-existent machine with a consistent interface, rather than the physical machine upon which it runs. C++ is also an HLL but because it compiles to machine code and has direct access to the underlying architecture, its level of abstraction is greatly reduced. It's every bit as portable as Java, but programs must be compiled separately for each platform. As a result, C++ programs take a little longer to develop, but execute many times faster than Java programs. By contrast, assembly language is a low-level language that symbolises every machine instruction as a simple, easy-to-remember mnemonic. As a result, there is very little in the way of abstraction. The only thing lower than assembly language is machine code itself ("banging the metal"), however assembly programming is a far more efficient and less error-prone means of producing that machine code. It is not portable, however. Every architecture has its own version of assembly language. Although C++ code can produce very efficient machine code by itself, assembly language produces the most efficient code as the programmer has complete control over the resulting machine code. However, C++ permits inline assembly language to be used wherever it is needed to maximise performance, so it could be classed as an HLL with low-level features. Java simply cannot compete with this level of control.
how to fix tajima 321 error
machine fool
A Japanese silk wholesale company
When this happened on our machine it was a loose wire on one of the start/stop switches
The price for a Tajima embroidery machine will vary depending on the size of the machine. Smaller embroidery machines can be purchased around $400 where as larger machines can cost up to $2800.
Check with http://www.PLRElectronics.com or http://www.madpunch.com It means that your X or Y driver (boards) are bad....
What dose error code d1.14 mean on tajima
I depends. It's either a sensor, it's wiring, or potentially the control card. Or it may be caused by wrongly positioned mechanisms of the main shaft.
The cast of Tajima - 2011 includes: Nobuhiro Tajima
The manual said to check the belt and sure enough it was broken in half. Unscrew the panel on the left hand side of the machine, where you put the allen wrench in to manually turn the needles up and down. The belt is right there. $110.00 to replace.
You can get the instruction manual from Stitch It Intl (link below).
Kaname Tajima was born in 1961.