An area of a network that shares a common address component. On TCP/IP networks, subnets are defined as all devices whose IP Addresses have the same prefix. Dividing a network into subnets is useful for both security and performance reasons. IP networks are divided using a subnet mask.
datagram subnet is connection oriented network.
A default subnet mask gives you classful addressing on octet boundaries. A non-default subnet mask implies that you are subnetting a larger network into several smaller ones.
255.0.0.0The default subnet mask of a class A network is 255.0.0.0
That is your subnet mask.
RIP VERSIONV1 can be seen to exclude subnet information from routing updates, this is because ripv1 is a classful routing protocol and does not support VSLM, this was corrected in RIPv2 where ripv2 does send out subnet mask's in the form of a prefix eg /24 which is the subnet mask of 255.255.255.0 or a class c address.
There is no technical term called "subnet mass number." It might be a misconstrued term. Subnetting is dividing a network into smaller subnetworks for better organization and security. Mass number is used in chemistry to denote the total number of protons and neutrons in an atom's nucleus.
A Subnet calculator is used for determining the attributes of an IP subnet including the start of it. Results of the subnet calculation include the access control lists, the subnet range and the subnet bitmap.
No. 192.168.12.1 - 192.168.12.254 is one subnet (assuming 255.255.255.0 subnet mask)
If you divide a net into several subnets, subnet-zero is the first subnet. Some older technologies don't allow the use of this first subnet.If you divide a net into several subnets, subnet-zero is the first subnet. Some older technologies don't allow the use of this first subnet.If you divide a net into several subnets, subnet-zero is the first subnet. Some older technologies don't allow the use of this first subnet.If you divide a net into several subnets, subnet-zero is the first subnet. Some older technologies don't allow the use of this first subnet.
datagram subnet is connection oriented network.
The default subnet would be 255.0.0.0 (class A)
It does not require a subnet mask.
Moving a subnet to left to save bits is known as a supernet.
No, all subnets must use the same subnet mask
You would also have to know the subnet mask.You would also have to know the subnet mask.You would also have to know the subnet mask.You would also have to know the subnet mask.
If this is a default subnet mask, then it would be a class C subnet mask. If you are subnetting a network and this is not the default subnet mask, then it could be either a class A or class B.
Depends on how you subnet it.