According to me the information about the 3 Volts DC batteries is incomplete i.e.The amp-hr capacity is not provided.If this is known then the answer would be 3X the amp-hr .
It is a isolator where the three pole phases are aligned digonally ie. all the pole phases are connected one behind another so that the jumpering can be done on the bus bar.
Parallel ports are easy to program and faster compared to the serial ports. But main disadvantage is it needs more number of transmission lines. Because of this reason parallel ports are not used in long distance communications. Let us know the basic difference between working of parallel port and serial port. In serial ports, there will be two data lines: One transmission and one receive line. To send a data in serial port, it has to be sent one bit after another with some extra bits like start bit, stop bit and parity bit to detect errors. But in parallel port, all the 8 bits of a byte will be sent to the port at a time and a indication will be sent in another line. There will be some data lines, some control and some handshaking lines in parallel port. If three bytes of data 01000101 10011100 10110011 is to be sent to the port, parallel port communication is faster then serial port.
System Board constitutes of multiple components connected by Pathways called BUSES. (Three Types of BUSES are there: Address, Control & DATA)
The wye is a type of power system where there are three current carrying legs making up the ends o the Y, a neutral current return leg and a solidly grounded to earth leg are connected at the middle of the Y. It is the most common type of power system and the most stable for multiple three phase and single phase loads. Another type of power system is a delta. Delta systems are more common in industrial settings with mostly three phase loads attached.
There are mainly three advantages: 1] less cost 2]data transfer rate is 100 mbps 3]it can support more length.
If each lamp is connected in parallel, then there are three 'paths' that draw current from the supply.
The brightness of three bulb would be mare than one
more current will be in case of parallel because in series combination resistence is greater with respect to parallel combination
If you connect them in series it will result in an 18V battery. If you connect them in parallel you will have a 6V battery with more capacity than one alone.
If three identical bulbs are connected in parallel to a battery, all three bulbs would have equal brightness.Kirchoff's voltage law states that the signed sum of the voltage drops around a series circuit is zero. A consequence of this is that, in a parallel circuit, the voltage across each parallel element is the same.There are effectively 6 series circuits in this example - battery and A - battery and B - battery and C - A and B - A and C - and B and C. These six combinations are also parallel circuits, and they are also in parallel with each other.
2 amps
If 3 identical 45-ohm resistors are connected in parallel, the net effective resistance of the bunch ...and the load seen by the battery ... is 15 ohms. The current supplied by the battery is60/15 = 4 Amperes.(This assumes that the battery is capable of supplying 4 amps at 60 volts, or 240 watts !)
12V. Every resistor in a parallel circuit shares the same voltage. It is the current that gets divided.
whats a quadrilateral with 2 sides not parallel and 2 sides parallel
As the lamps are identical, and all three draw a current of 6 A, then each lamp must be drawing 2 A. So, with one of the lamps disconnected, the current drawn from the supply will reduce to 4 A.
Nothing
If three lamps are connected in parallel and one blows out, the current in the other two does not change. This assumes that the net change in total current does not cause the power source to change voltage.