RJ11 is a physical interface often used for terminating telephone wires. It is probably the most familiar of the registered jacks, being used for single line POTS telephone jacks in most homes across the woeld
An RJ-11 is the jack that is used on the telephone line. An RJ-45 is the jack used to hook up to the cable for the internet.
RJ 11 (Registered Jack), is a Twisted Pair cabel, commonly used for telephone wiring and 10BASE-T Ethernet.
The type of connector is used by the analog modems is RJ11 or RJ45.
RJ45 is a 8 pin connector used on networking(ethernet) cables RJ11 is 6 pin connector used on telephone cables in the USA
Ethernet and modem.
RJ11(Registered Jack-11) has 4 to 6 pins. Generally 4 ports are there in RJ11.
Phone lines using the RJ11 jack (the phone jack) have 4 wires...Colors of those are black yellow red and green. The Red(tx) and Green(rx) are for LINE1 (which is the primary phone number, usually) The Yellow(Tx) and Black(Rx) lines are for LINE2 (Which is for the secondary phone line, which most Phone services do not include in their standarized packages).
The type of connector is used by the analog modems is RJ11 or RJ45.
The RJ11 Jack, also known as a Registered jack, is used to connect electronic equipment to a local telecommunications service. The RJ11 jack is usually plugged into a six-pin 6P6C jack.
RJ45 is used with ethernet cables in computer networking while RJ11 is used in connecting telephone units.RJ45 contains more wires than RJ11and RJ45 is physically bigger than RJ11 to accommodate the extra wires
"RJ11"
RJ11 Cable
rj11 cable is usually used for a phone line so for computers this particular cable can be used to connect to a dial up connection or dsl connection
RJ11
No, a conversion can not be made due to the different size of cables that each terminal end uses. An RJ45 uses a Cat , 8 wire cable where as a RJ11 uses a smaller 4 wire cable. The sockets for the RJ45 will be too wide to allow a RJ11 connector to securely connect to it.
RJ45 is a 8 pin connector used on networking(ethernet) cables RJ11 is 6 pin connector used on telephone cables in the USA
now currently use for rj 45
rj11
terminate the RJ11 end and on the RJ45 end crimp the 4 wires in the 4 middle slots. run the wires straight through, no crossover