0
What else can I help you with?
What is difference between dynamic and volumetric compressor?
what is difference between dynamic and volumatic compressor
What is the difference between MS and SS in WiMAX system?
what is difference between mild steel and stainless steel
What is difference between scope and superscope?
Both are same no difference Both are same no difference
What is the method to find the difference between two sets in Python?
To find the difference between two sets in Python, you can use the "-" operator or the difference() method.
Is it safe to plug an air conditioner to a computer surge protector?
It will very likely damage the surge protector
What does a bad IAC cause?
the engine to stall and surge at idle
What is the cause of stall and surge in compressor?
stall and surge is caused when the flow in the compressor loses enthalpy and static energy so that it does not have enough power to approach the end of the axis; thus it remains in the annolus of the compressor and creates a stall cell. these cells gradually join each other and create stall zones which are rotating about the axis and are some times called rotating stall. if this stage does not get stopped, the stall cells will cover the whole annolus and will stop the fluid flow through the stages of the compressor and finally lead to surge. if surge happens, the compressor will be out of order.
What is the difference between an electrical surge and a brownout?
A surge is an over voltage and over current situation and a brownout is an under voltage situation.
What is Stall or surge margin graph?
A stall or surge margin graph shows the operating limits of a compressor or turbine system. It typically plots pressure ratio or flow rate against surge margin, which is the distance to the surge line. This graph helps engineers ensure that the system operates safely within its design limits to avoid unstable operation.
What is difference between surge absorber and surge suppressor?
There is likely no difference. Neither is accepted terminology for a surge suppressive device (SPD). If these products have been tested by safety organizations such as CSA (Canada) or UL (US) or tested to international surge standards (IEEE, IEC), then they should bare the correct terminology, otherwise, they are not tested to provide protection to equipment during a surge. Surge Absorber acts as a load that utilizes the high current until it exhausts. but the surge suppressor diverts the high current into ground without reaching the sensitive parts of the circuit. Surge absorber degrades faster than a surge suppressor.
what is the difference between stall and store?
well, for stall itself is (countable) a compartment for a single animal in a stable or cattle shed, or stall can be an action that is intended to cause or actually causes delay.
What is difference between stall and rated RPM?
rated rpm is the maximum number of complete rotations that a rotor can rotate for every minute
What is the difference between max torque and breakdown torque of a electric motor?
Max torque and breakdown toarque are the same...,.the point at which a motor will stop/stall.
What is the difference between spike and surge in electrical systems?
Surge suppressor, as name suggests suppresses and regulates the voltage and makes the power constant in a case of a spike or surge. While a protector simply detects the surge and turns the unit off. Suppressor is good for things like computers, where you don't want to keep turning on and off.
Why does an engine surge and then slow sporadically and then stall on a 1971 Ford Taurus?
Stopped up exhaust.Cat converter is bad and blown back into muffler causing stoppage.
What would cause my 1988 Mitsubishi Montero with manual tansmition to lose power stall or surge when I accelerate at higher speeds 65 to 75 MPH?
cranck sunser
What is the difference between a surge protector and a circuit breaker in terms of protecting electrical devices from power surges?
A surge protector is a device that diverts excess voltage from reaching your devices during a power surge, while a circuit breaker is designed to interrupt the flow of electricity when there is an overload or short circuit. Surge protectors are specifically for protecting against voltage spikes, while circuit breakers are for preventing electrical fires and damage to the wiring in your home.
