Over-specification is where there is too much information about what size somethign is or how do or make something.
For example a piece of rope that is to be cut in half.
Correct specification would read: Rope length 50m, cut at 20m from the left.
Over-specification would read would read: Rope length 50m, cut at 20m from the left and 30m from that right.In this case "30m from the right" is too much and can be computed from what was said before.
It is rather dangerous because designers tend to update specification at the specific part sub part without considering the whole. This can lead to serious problem when the original updater isnt present to confirm the correct spec.Eg Consider what would if we need 5 more meters on the left piece and someone updated the spec badly. The overspecificed version would read.
Rope length 50m, cut at 25m from the left and 30m from that right. ... which is simply not possible, and creates a problem figuring out which number was updated and which is correct.A detailed description of what the computer is and what it's good at.
PnP
1.wrong specification when delivered.
it is preasure rating grade
8
£2.50
Data Over Cable Service Interface Specification
it leads to specification because you separate the populations and a population with a certain trait will become dominant over a certain area of land or mass.
A job specification defines the duties of the job. They are used to set pay rates. They also help to resolve any conflicts over what a job's duties entail.
AToM is a specification sometimes used by content aggregators to distribute content. AToM is short for Any Transport over MPLS.
AToM is a specification sometimes used by content aggregators to distribute content. AToM is short for Any Transport over MPLS.
AToM is a specification sometimes used by content aggregators to distribute content. AToM is short for Any Transport over MPLS.
AToM is a specification sometimes used by content aggregators to distribute content. AToM is short for Any Transport over MPLS.
Specification of animals.
It is the radial distance from spindle center to bed guide ways so that it can be turned with out fouling bed and it is termed as swing over bed. If it is a gap bed machine then another swing specification termed as swing over gap. Another swing specification is swing over cross slide. This specification become important while machining a job in between centers.
General Specifications•General specification are written•General Specification may include:General site requirement- Health and safety- Measures against environmental pollution- Security measuresParticular Specification•It contains particular specification.•Example :- Strength and other properties of steel- Strength of concrete- Specification of bricks- Specification of electrical itemsEtc.
your face is the specification