answersLogoWhite

0


Best Answer

200 MHz

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the clock speed of a DDR16000 RAM module?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is procesor ram cach clock speed?

The processor RAM Cach clock speed ranges between 3.3 to 4.00 GHz.


Why is the speed of ram and secondary storage an issue for the CPU?

clock speed


What is CPU speed for ProMos Technologies 1GB part?

Isn't ProMos a RAM vendor? If this is the case, I believe ProMos shipped their 1GB part at PC-DDR2 5200, or 667MHz for the clock frequency of the RAM itself. The processing unit built into the ram probably doesn't have a discernible clock speed, or it is synced with the RAM's clock speed.


Can you use ram with different speed in single motherboard at different sloti.e Ram 333mhz with 256mb and 512mb Ram with speed of 400mhz.?

Depending on what your motherboard can handle, all the RAM (regardless of clockspeed) will clock to the same speed.


Which of the following is the approximate clock speed of ram labeled ddr2100?

C. 266MHz


What is the fastest clock speed of a motherboard RAM?

ACPU has multimedia instructions called


Can you install two different ram clock rates like a ddr3 1600 and a ddr3 1333?

yes, you can. but both will run on the lowest component speed.. so your ddr3 1600 module will only run at 1333.


What options have an effect on the speed of the communication between the CPU and RAM in a computer?

CPU front side bus RAM clock rate


How does double data rate ram achieve its doubled speed?

DDR RAM doubles its speed by using both the rising and falling edge of the clock signal. The advantage of DDR and QDR signaling is that the clock rate does not have to be increased. So the integrity of the signal is not compromised since the throughput can be increased without increasing the clock rate.


How can the installation of RAM affect the clock speed of the processor?

It doesn't; the clock speed of your RAM is governed by your Front Side Bus clock frequency. With more RAM installed your PC will run faster, but the CPU clock speed is not responsible for this. Actually,installing RAM would never effect the processor speed .AS there is a clock generator(eg:8284-A which was being used in the 8086 processor long back) which determines the clock of of the processor which in term is responsible for the speed of the processor.for eg:Every read or write operation takes 4 clock cycle for instance & if ur processor's clock speed is 1 mega hZ frequency i.e a clock pulse is of 1 micro seconds i.e ur write operation will take 4 micro sec & suppose my processors's clock speed is 2 mega hZ frequency i.e a clock pulse is of 0.5 micro seconds i.e my write operation will take only 2 micro second. now what actually RAm is? it is just a temporary memmory provided to the prcessor for communication. processor hardly communicates with the hard disk. whatever data is required by processor it is first transfered to the RAm first and processor retrives it from there.so if u have larger RAm large data can be stored in it & would not want it regularly from the hard disk. there r a lot of other things involved like the type of architecture and cache memmory.however ,i hope i would have answered to this question. BY:- KALLAT VINAY(mumbai-vasai computer engineer).


Practical example of where SRAM used for?

The "S" stands for Synchronous RAM. By Synchronous that means it worked with the system clock and the speed of the RAM is the same as the speed of the system bus. So if the system bus is operating at 100MHz then Synchronous RAM also operated at 100MHz. It has since been replaced by Double Data Rate RAM (DDR). Double Data Rate goes twice as fast as the system clock, it sends data on the upswing of the clock and again on the downcycle of the system clock so it can send data twice as fast as the Synchronous RAM which sent data once per clock cycle. Hope this helps.


What is clock speed expressed as?

A rating of MHz, or GHz. Usually GHz when dealing with a processor. MHz when dealing with RAM.