0
What else can I help you with?
Device that protect computer in the event of a loss of power?
A surge protectorAnswer 2:Surge protectors provide some protection, but the only surefire way to protect an electronic device during lightning storms is to unplug the device.
What should they buy to protect their computer during future lightning storms power surge circuit board ground wiresurge protector?
A surge protector
Why do you lose unsaved data on you computer during power failure?
There two types of memories in cpu .1.temporary ,2.permanent. Whenever doing any work with out saving the data then it store in temporary memory until the shutdown the computer or power cut.
How do computer users protect their computers from too much electricity?
To protect a computer completely from electrical problems you would have to keep it unplugged. Unfortunately this makes it useless. Using surge protection on the power supply is a simple and relatively cheap protection from spikes in the power supply. A UPS or uninteruptible power supply can be set up to allow the computer to run for a period of time after a breakdown in the power supply. These are more expensive the longer they can supply power, and are often set up to supply power for just long enough to do a save and tidy shutdown of the computer.
What is the pre-boot sequence?
Preboot Sequence During startup, a Windows Server 2003-based computer initializes the boot portion of the hard disk and the preboot sequence begins. This sequence consists of four steps: • The computer runs power-on self test (POST) process to determine the amount of physical memory; and • The hardware components are present. • If the computer has a Plug and Play (BIOS), enumeration and configuration of hardware devices occurs. • The computer BIOS locates the boot device and loads and runs the master boot record (MBR). Note: Windows Server 2003 modifies the boot sector during installation so that Ntldr loads during system startup. Therefore you should disable the Boot Sector Virus Protection in your BIOS Setup.
Device that protect computer in the event of a loss of power?
A surge protectorAnswer 2:Surge protectors provide some protection, but the only surefire way to protect an electronic device during lightning storms is to unplug the device.
What date did the ww2 blackout began?
The blackout during World War II began in the United Kingdom on September 1, 1939, shortly after the outbreak of the war. This measure was implemented to make it more difficult for enemy aircraft to identify targets and to protect cities from bombing raids. Other countries involved in the war also instituted blackout measures in the following years to enhance their air defense.
What is most likely to happen during a thunder storm?
a blackout
How do you disable an internal component in a notebook computer?
You do it in CMOS setup, usually by pressing F2 during bootup, but the exact key combination varies from device to device.
Why did you need the blackout in World War 2?
You needed a ''Blackout'' because, if everyone had their lights on during a bombing raid then it would be easy for the bombers to spot you!
How can you easily tell if a computer is designed to comply with Green Standards?
If the computer is recently purchased, look for an "EnergyStar" in the manual, or during the bootscreen of the computer. This ensures that the computer consumes a low amount of energy when compared to the possible amount of energy any given computer can consume. Also, in the manual look for the RoHS symbol, this company's acronym stands for "the restriction of the use of certain hazardous substances in electrical and electronic equipment". http://www.rohs.gov.uk/
How do you make a sentence with the word chaotic?
during the electric blackout, traffic was chaotic.
How did people keep there houses safe during the blackout?
they ate there children. for real.
What is the difference between black out and brown out?
Your electricity goes off during a blackout. Your lights flicker during a brownout
Did Roosevelt island tramway stopped during 1977 blackout?
Yes, the Roosevelt Island Tramway did stop operating during the 1977 blackout in New York City. The tramway was not equipped to handle the power outage and ceased service for safety reasons. Passengers were left stranded on the tram until the power was restored, leading to a dramatic situation that highlighted the vulnerabilities of the city's infrastructure during the blackout.
What happened to people who didnt comply to the blackout during the wars?
They most possibly died
How do you protect against a power surge?
The easiest way is to use an UPS. It's a device that provides voltage during a limited period of time. If you are more than a real company their are other solutions like a generated but keep in mind that this cost you a lot of $.
