"Flame" is the visible energy when burning something.
"Heat" is given off a flame and countless other things.
Flame produces heat, but heat does not always generate from flame, and heat almost never produces flame (friction might count).
And if you want the definitions:
HEAT: a form of energy that is transferred by a difference in temperature.
FLAME: the process of combustion of materials producing heat and light and (often) smoke.
If you want to think of it a different way:
Flame is what you see when you look at a fire and heat if what you feel from the fire.
the difference is the heat addition type In Otto Cycle the heat addition is Isochoric ((constant volume)) In Diesel Cycle the heat addition is Isobaric ((constant pressure))
No, because any flame has heat , and if you try to freeze it , the freezing agent would either: a) melt the freezing agent...... b) burst it into flames...... c) or both.
what is difference between dynamic and volumatic compressor
what is difference between mild steel and stainless steel
Both are same no difference Both are same no difference
Energy flows from the Bunsen burner because heat is given off, creating a chemical reaction between the water and flame. This causes the water to heat up until the flame reaches 100 degrees and then the water boils (this is the waters boiling point).
There is a real difference. A flame-retardant bedding has filler that is not flame resistant, but the outer later is flame resistant. As for inflammable bedding, both the filler and the outer layer are both flame resistant.
difference schematic diagram between carnot heat engine and heat engine
the blue flame is hoter than the yellow flame.http://en.wikipedia.org/wiki/Flame hope this gives u the right picture
what is the difference between product analysis and heat analysis
the goldfish is a living thing
manufacturing process of steel plates difference between heat and product analysis ?
Go with the gas heat.
You can calculate the heat of a flame by its color. Normally the hotter that the flame is the bluer that the flame will burn. If the flame is red that means it is burning at a cooler temerature.
manufacturing process of steel plates difference between heat and product analysis ?
A flame bends toward the wind because the flow of air carries the heat and combustion products away, creating an area of lower pressure on the windward side of the flame. This pressure difference causes the flame to lean in the direction of the wind.
Flame retardant means the material will burn at a slow rate. However, flame resistant is defined as resisting flames and the power to withstand any type of flame.