Density, in terms of matters indicate the mass per unit volume, for example oil will be more dense than water.
For electronics high density indicates more closely packed with components. For example a high density board will have many more components than a simple circuit board.
There should be low dependence and high interaction between the modules. The dependence should be low so that the module can work in absence of another module. So, there should be low coupling ad high cohesion in software design.
If you are referring to Giga Bytes in a mega bit (Bytes are different to bits - 8 bits makes a byte) and the m to M (meaning mega) 70/8 = 8.75 so 70Mb = 8.75MB 1024MB=1GB so then 8.75/1024 or 0.00854492188 GB in 70 Mb, but if you were referring mb to MB (mega byte) then simply 70/1024 = 0.068359375 GB are in 70 MB. The capitals are important - so make sure you get them right or say the long name.
Low Density Fibreboard
The key difference between a D latch and an SR latch is in how they are triggered to change their output. In an SR latch, the output changes based on the state of the S (set) and R (reset) inputs. When both inputs are low, the latch holds its current state. When S is high and R is low, the output is set to high. When R is high and S is low, the output is set to low. However, when both S and R are high, it can lead to unpredictable behavior. On the other hand, a D latch changes its output based on the state of the D (data) input. When the clock signal transitions from low to high, the D latch captures the input data and updates its output accordingly. These variances impact their functionality in digital circuits as the D latch is more commonly used for data storage and synchronization, while the SR latch is more prone to issues like race conditions and unpredictable behavior due to its set and reset inputs.
high directivity high beam width low power transmitter is needed
The difference is that,an oil is a dark viscous liquid with high density and low rate of diffusion why gas is a well pronounce substance with low density and rate of diffusion. The difference is that,an oil is a dark viscous liquid with high density and low rate of diffusion why gas is a well pronounce substance with low density and rate of diffusion.
The difference between low percent error and high percent error is one is low and the other is high
A box with high density will have more mass packed into the same volume compared to a box with low density. This means that the high-density box will be heavier and contain more material in the same space as the low-density box.
high carbs are when carbs are high and low carbs are when carbs are low.
High-density polyethylene (HDPE) has a higher density and stronger intermolecular forces, making it more rigid and resistant to heat and chemicals compared to low-density polyethylene (LDPE). LDPE is more flexible and has less strength and chemical resistance, but it is easier to process and has better impact resistance.
The main difference between high quality and low quality energy is in the perception. This will facilitate the proper grading of tasks with the high tasks using high energy and low tasks low energy.
The difference between high relief and low relief is that high relief has more depth and low relief is more casual and not as 3D. In high relief, it's much closer to 3D.
Low is at high temperature High is at low temperature It kind of has to do with the way the shower is at the humidity rate
range
pitch.
the moon
the diffrencce between high tide and low is a high tide is by the gravitaion pull of the moon and/or the sun and a low tide is in the middle between the moon an sun