0
What values are used when configuring HyperTerminal for connecting to a Cisco router's console port?
Wiki User
∙ 12y ago
The port that is connected can either be COM1 or COM2 depending on the communication port.
Wiki User
∙ 12y ago
Wiki User
∙ 10y agoSet it to connect via COM port with:
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Add your answer:
Earn +20 pts
The network administrator needs to connect two routers directly via their FastEthernet ports What cable should the network administrator use?
straight cable is needed when connecting two computer periperhals. A cross over is used when connecting a computer to a network hardware (router, swirch, etc..)
What is stack routers?
To stack routers means to physically stack routers. Some stack a couple of routers on top of each other if they plan to just use them as switches or similar.
Sophisticated networks generally use which of the following hardware devices to ease the flow of data packets throughout the network?
Modern networks used two devices for the data packets within the network will flow easily. The two devices are the routers and switches.
How does DHCP allow devices to communicate?
They use DHCP to assign IP Addresses to Devices such as Windows XP, Networking flashcards, OIt DHCP and BootP services, and connecting routers. The definition for DHCP is Dynamic Host Configuration Protocol.
Where is a AOSS button on a telus router?
The Telus Routers do not have an AOSS button. I believe only Buffalo Routers have one.
Which item is an encapsulation protocol that can be used in cisco routers when configuring subinterfaces?
The ISL protocol can be used in Cisco routers when configuring the subinterfaces.
What are sold for home use for configuring as firewalls and are capable of performing network address translation?
routers
When is rollover cable used in a network?
for connecting 2 routers through their AUX ports!
What type of connector is used to interface with a cisco routers console port?
RJ-45
What is the command line interface used for on a cisco router?
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
What is the command line interface used for a Cisco router?
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
What is the use of console port in cisco switches?
Like Cisco routers, most Cisco switches run IOS, and can be configured in a similar way. Older non-IOS switches still use the console port to configure them, just like the routers.
Can you increase the download speed by connecting to several internet routers?
You can only connect to one router at a time ;)
What equipment is used in connecting two wireless routers?
Wireless routers can be connected via an ethernet cable in the same way as wired routers. If the second router has a client mode feature then the routers can also be connected wirelessly otherwise the second router will only function as a wireless access point.
Do wireless routers provide internet access or do you still subscribe to an internet provider?
Routers (wireless or with wires) do not provide internet access. Routers are for the purpose of connecting more than one computer to one internet modem. You need and internet provider
Which command must be entered when connecting two routers without external DCE devices via a serial link?
Clock rate.
What type of cable is being used if a network administrator is connecting two Cisco routers and uses the 100BaseTX standard?
100BaseTX implies Cat5 or better RJ45 cables, and between two routers you need a crossover cable.
