The 124 proportion in concrete technology is 1 bucket of cement to 2 buckets of sand to 4 buckets of aggregates to 1/2 bucket of water.
Type I, Type II (which have 100 pins) and Type III (which has 124 pins). (side-note from Kimberly) just to clarify because I didn't get it at first, Type I AND type II both have 100 pins lol. 6th Edition, Pages 1110
174 no ........ the uplink is 890-915 & down link is 935-960.....MHz each channel having band width of 200KHz & using by 8 subsciber.... so 25MHz/200Khz ......=125...so there are 125 channels present in GSM900 but one channel is use as a guard so only 124 channel present in GSM900
For IPS-Height - Male 165 cm Pahari Male (general also) & ST (not the SC/ OBC) - 160 cmFemale 150 cm Pahari Female (general also) & ST (not SC/ OBC)- 145 cmChest - Male Minimum 84 cm. Expansion 5 cm.Female Min 79 cm expansion 5 cm.(Those can't expand the chest go to next service. If expansion is less during 1st Medical, i.e. just after interview; during second Medical, i.e. after the result, or appeal, expansion can be shown.)Many people fail in this test of chest expansion.(I know some people who have cleared this exam during the second Medical Test, i.e. after the Medical Exam conducted after the declaration of Final result)Eye sight - 6/6 or 6/9 distant vision for good eye. 6/12 or 6/9 for worst eye. Near vision J 1 for good eye. J2 for worst eye. The correction is by lensesonly. High standard for the Colour-blind test. No inherent night blindness. Vision should stereoscopic.Blood pressure (High) - Age 23 - 123, age 24 - 124, age 25 -122, age 28 - 124, age 30 -125, age 32 - 126, age 34 - 127.Ladies should not be pregnant at the time of Medical Test.Ear- good listening & normal ear cavity. 1000 to 4000 frequency hearing impairment shd not be more than 30 decibels.Nasal- candidate should not stammer while speaking
standard for data transmission in a local area network that can extend in range up to 200 kilometers (124 miles). Although FDDI logical topology is a token ring network, it does not use the IEEE 802.5 token ring protocol as its basis; instead, its protocol is derived from the IEEE 802.4 token bus timed token protocol. In addition to covering large geographical areas, FDDI local area networks can support thousands of users. As a standard underlying medium it uses optical fiber, although it can use copper cable, in which case it may be refer to as CDDI. FDDI uses a dual-attached, counter-rotating token ring topology.FDDI was considered an attractive campus backbone technology in the early to mid 1990s, but FDDI has since been effectively obsoleted by fast Ethernet and, since 1998, by Gigabit Ethernet due to their speed, lower cost, and ubiquity.FDDI, as a product of American National Standards Institute X3T9.5 (now X3T12), conforms to the Open Systems Interconnection (OSI) model of functional layering of LANs using other protocols. FDDI-II, a version of FDDI, adds the capability to add circuit-switched service to the network so that it can also handle voice and video signals. Work has started to connect FDDI networks to the developing Synchronous Optical Network SONET.A FDDI network contains two token rings, one for possible backup in case the primary ring fails. The primary ring offers up to 100 Mbit/s capacity. When a network has no requirement for the secondary ring to do backup, it can also carry data, extending capacity to 200 Mbit/s. The single ring can extend the maximum distance; a dual ring can extend 100 km (62 miles). FDDI has a larger maximum-frame size than standard 100 Mbit/s Ethernet, allowing better throughput.Designers normally construct FDDI rings in the form of a "dual ring of trees" (see network topology). A small number of devices (typically infrastructure devices such as routers and concentrators rather than host computers) connect to both rings - hence the term "dual-attached". Host computers then connect as single-attached devices to the routers or concentrators. The dual ring in its most degenerate form simply collapses into a single device. Typically, a computer-room contains the whole dual ring, although some implementations have deployed FDDI as a Metropolitan area network
A bachelor's degree in most areas can require between 124 to 128 college credits particular to a specific program of study. This would be based on a college or university that operates on a regular two semester academic year which is the most common. For institutions that operate on a tri-semester or quarter-semester it would be quite different. That being said, the Bachelor's degree - in most cases - is designed as a four year program of study, provided the student is full-time and follows their chosen program of study as prescribed by the college or university, and also provided the individual does not require prerequisite or developmental coursework as a result of basic skills testing. The minimum credit load for a full-time student is no less than 12 credits per semester. However, to complete the degree within the four years, a credit load of approximately 15 to 18 credits is recommended. For individuals who work or who have other responsibilities that would prohibit them from attending full-time, completion of the degree may take twice as long. Still, some of this time can be cut down by attending summer sessions and/or interim sessions. In addition, the bachelors and associate degrees are referred to as undergraduate degrees while the Masters and Doctorate degrees referred to as graduate degrees.
25% of 124 = 31
M 15 grade - 1:2:4Cement bags required - 6.5 bagsCement required - 325 kgs
124/124 = 1 124/62 = 2 124/31 = 4 124/4 = 31 124/2 = 62 124/1 = 124
The multiples of 124 between 1 and 10 are:1 x 124 = 1242 x 124 = 2483 x 124 = 3724 x 124 = 4965 x 124 = 6206 x 124 = 7447 x 124 = 8688 x 124 = 9929 x 124 = 111610 x 124 = 1240
42% of 124 = 42% * 124 = 0.42 * 124 = 52.08
90% of 124= 90% * 124= 0.9 * 124= 111.6
6% of 124= 6% * 124= 0.06 * 124= 7.44
87 + 37 = 124
20% of 124= 20% * 124= 0.2 * 124= 24.8
56% of 124 = 56% * 124 = 0.56 * 124 = 69.44
48% of 124 = 48% * 124 = 0.48 * 124 = 59.52
19% of 124 = 23.56= 19%/100% * 124= 19/100 * 124= 0.19 * 124= 23.56