in a dc machine core losses occur both in stator and rortor but stator core losses are negligible as compared to rotor core losses because in stator constant dc flux is given and the statot conductor is stationary so there are no eddy losses and as the flux is stationary there are no hysteresis loassses also but in rotor armature winding is placed so here alternating field is induced which cuts the rortating conductors of rotor thereby inducing eddy as well as hysteresis losses fo any more info. contact zombie
It is doubly excited if it is sparately excited dc motor, singly excited if it is self excited machine
Notebook Era Web Site - Notebook Drivers Online Download http://www.notebookera.com http://notebook-drivers.notebookera.com http://opendrivers.notebookera.com The real answer is: The DC controller is a card inside the notebook that converts voltage to CPU core voltage.
This helps the machine to stop easier. It is a much easier process to use and safer for everyone involved in the process.
The most common faults are i know as below: a) brush carbon arcing due to high current and friction; b) dust or dirt; c) over temperature due to high ambient and excessive use; d) overload and winding insulation failure e)inadequate protection against heat and poor ventilation
The components of NIC are : buffer pulse transformers lan dc/dc converters lan filters
The condition for maximum efficiency of a d.c. machine is that VARIABLE LOSSES must be equal to CONSTANT LOSSES i.e., variable losses = constant losses..
Losses mean energy losses, which cost money, and most people like to know how much a machine is going to cost to run.
How to calculate iron losses in dc machine
to reduce the eddy current loss in the machine
Constant losses Those losses in a d.c. generator which remain constant at all loads are known as constant losses. The constant losses in a d.c. generator are: (a) iron losses (b) mechanical losses (c) shunt field losses
What motor is NOT suitable for use as a DC machine?
The slip rings are the most important brush in DC machine.
swinburne's test on dc shunt machine is to predetermine the efficiency of the dc machine , but it is not accurate it is just like estimation of efficiency of dc shunt machine when it is run as a motor and a generator............................
it is a machine which operates on the dc power source.
Laminations minimize eddy currents, or current flow across the iron parts. This is one method to minimze stray losses.
05 types of dc machines
equation of ac machine