0
A switch. Each port has a separate path to each of the other ports on the switch. On a hub, all the ports are tied together into 1 single port. Think of a switch as an 4 lane freeway with 8 entrances and exits; a hub is a one lane highway with the same 8 entrances and exits. It can pass data from only one port to another port- switch can connect 4 ports to the other 4 ports (or 8 to 8 or 16 to 16, you get the idea)
A switch is quite a bit more complicated AND is generally more expensive: between 20% and 300% more than a hub with the same number of ports BUT it's very useful on a busy network (business especially.)
What else can I help you with?
What is a good number to expect for web traffic?
There is no good number for web traffic, the number is critical is conversion. If your web traffic converts - then the more you get the bigger the profits
Which sorting algorithm is more efficient for large datasets: quick sort or selection sort?
Quick sort is more efficient for large datasets compared to selection sort.
Which sorting algorithm is more efficient for small datasets: bubble sort or selection sort?
Selection sort is more efficient for small datasets compared to bubble sort.
What is optical networking hardware?
Optical networking hardware entails the various components used in optical technologies. Some of the common hardware include routers, optical fiber, electronic devices and so much more.
What are the benefits of replacing a hub with a switch?
Basically, with a hub each network card has to wait it's turn to transmit data, therefore its slower than a switch which allows them all to talk(transmit) at the same time switching the data stream directly to the ports that need to receive the data. The switch knows this by comparing the IP address to the MAC ADDRESS of the card, making a switch a lot more intelligent than a hub.
Which is more efficent for networking traffic a switch or a hub?
It depends on the number of clients in the LAN segment, but in general a switch is more efficient than a hub.
Which is more effcient for networking traffic a switch or a hub why?
Switch because it is at least a little intelligent and can send data packets to the correct port.-----------A switch also regenerates the network signal, where a hub does not.
Why are roundabouts considered to be more efficient than traditional intersections?
Roundabouts are considered more efficient than traditional intersections because they help reduce traffic congestion, minimize the likelihood of collisions, and improve traffic flow by eliminating the need for traffic signals.
What does segment means in networking?
In networking, a segment refers to a portion of a network that is isolated from other sections, typically defined by a specific physical or logical boundary, such as a local area network (LAN). Segmentation enhances performance and security by limiting broadcast traffic and allowing for more efficient data transmission. It can also facilitate better management and troubleshooting within the network. Overall, segments help organize and optimize network resources and traffic flow.
Should you switch to more fuel efficient cars?
Yes you should. They will cause less pollution.
What are 100base T hubs?
100Base-T hubs are networking devices that facilitate the connection of multiple computers and devices in a local area network (LAN) using Ethernet technology. They support data transmission speeds of 100 Mbps and operate over twisted-pair cabling, typically using the TIA/EIA-568 standard. Although they were common in the late 1990s and early 2000s, hubs have largely been replaced by more efficient devices like switches, which can intelligently direct data traffic. Hubs operate at the physical layer of the OSI model and do not filter traffic, making them less efficient compared to modern networking solutions.
What is Multiprotocol router?
A router that supports two or more communications protocols, such as IP and IPX. It is used to switch network traffic between different LANs located throughout the enterprise as well as to switch LAN traffic to WANs.
What replaced X25?
X.25 was primarily replaced by newer networking technologies like Frame Relay and later on, IP-based protocols such as ATM (Asynchronous Transfer Mode). These technologies offered higher data transmission speeds and more efficient networking capabilities, making them more suitable for modern networking requirements.
Should more companies switch to VoIP systems?
I believed more company will switch to VoIP since it is very cost efficient and can be accessed anywhere in the world as long there is an internet connection.
A hub is smarter and more efficient than a switch and keeps a table of all the devices connected to it?
False
How is a wireless access point that is also a bridge more efficient in handling network traffic than a wireless access point that is not a bridge?
A Bridge assist in handing network traffic and can direct known traffic to its destination.
Is connecting a switch in Ethernet Lan is beneficial?
Yes, using a switch allows you to connect more clients in your LAN. In addition, it limits the amount of traffic collisions in the LAN segment as well, allowing better performance and throughput of traffic.
