answersLogoWhite

0

IPV6 is relatively new and doesn't work everywhere yet.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Why is NAT not needed in IPv6?

Any host or user can get a public IPv6 network address because the number of available IPv6 addresses is extremely large.​ smb


Does ipv6 support available for FaceTime?

Yes, FaceTime supports IPv6. Apple has implemented IPv6 compatibility across its services, including FaceTime, to ensure that users can connect seamlessly in environments where only IPv6 is available. This support allows for better connectivity and performance in networks transitioning from IPv4 to IPv6. Users should ensure their devices and networks are properly configured to utilize IPv6 for optimal performance.


How many available IPv6 addresses are there in a 64 allocation?

18,446,744,073,709,551,616


How many /64 subnets are available in a /48 prefix?

There are 65,536 subnets available in an IPv6 /48 block.


Can a new IP addressing scheme increase the number of available IP addresses?

Yes and that is called IPV6


How many IPv6 address are possible?

In theory there are 264 available network allocations in ipV6. It is not known how many are actually in use at this time. For a very clear comparison, in IPv4 there is a total of 4,294,967,296 IP addresses. With IPv6, there is a total of 18,446,744,073,709,551,616 IP addresses in a single /64 allocation.


What are the uses of ipv6 for commercial?

what is the commercial use of ipv6?


What is the length in bits of a logical IP address IPv4 and IPv6?

32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).32 bits (for IPv4), or 128 bits (for IPv6).


Does Windows XP support IPv6?

Short answer - yes.You need to be running Service Pack 1 at a minimum.Service Pack 2 has an even more complete IPv6 stack.To enable IPv6 on XP, open a command prompt window and type:C:\> ipv6 /?Did you then see this result?:C:\> ipv6 /?Could not access IPv6 protocol stack - the stack is not installed.To install, please use 'ipv6 install'.If you did get the above result, simply type:C:\> ipv6 installIt will take a few seconds, and then your Windows XP system will be fully IPv6 enabled.


What functions are available with the Cisco 4500?

Some functions that are available on the Cisco 4500 include Quality of Service and compatibility with IPv6 traffic. Another feature available is compatibility with one or two supervisors on the switch.


Why vrrp cannot be implemented in IPv6?

It is currently available in IOS-XR. Check Feature Navigator to track where else it gets implemented.


When a Cisco router is being moved from an IPv4 network to a complete IPv6 environment which series of commands would correctly enable IPv6 forwarding and interface addressing?

To enable IPv6 forwarding and configure interface addressing on a Cisco router moving to an IPv6 environment, you would first enter global configuration mode and enable IPv6 routing with the command ipv6 unicast-routing. Next, you would access the specific interface using interface <interface-name> and assign an IPv6 address with the command ipv6 address <ipv6-address>/<prefix-length>. Finally, use the command no shutdown to activate the interface.