0
What else can I help you with?
Replaced the thermostat and the furnace works but wont turn on?
Sounds like you might have a blown transformer, or a blown fuse on the transformer. Hope for the fuse. Its on the Furnace. Be sure your white wire is on the heat side of the thermostat, and the red wire is on the correct terminal also. The transformer can be checked with a voltmeter.
Why was power lost to a heat and air thermostat?
The power to the thermostat comes from the transformer in the furnace or air handler whichever you have. 1) the power to the furnace/AH is off, 2) the control fuse that protects the transformer is blown, 3) the transformer is defective, 4) the wire between the furnace and the thermostat got cut.
Has the furnace fuse blown in your home?
Check the fuse in your furnace to see if it has blown.
What should I do if my furnace has a blown fuse?
If your furnace has a blown fuse, you should first turn off the power to the furnace and then replace the blown fuse with a new one of the same type and rating. If the fuse continues to blow, it may indicate a larger issue with the furnace that requires professional repair.
Why do some elements in an electric furnace not come on?
Blown fuses or bad elements.
Why primary side of transformer blown?
It is either a short in (1 or more) of the windings (if its multi-phase) or the applied voltage was too high. What is the application, size (wattage), voltage, a number of phases for this Xfmr? I might be able to help you troubleshoot it further with this information.AnswerIt depends on what you mean by 'blown'! Do you mean the primary fuse has operated? If so, then it's likely the transformer's load has exceeded the capacity of the transformer.
Could fuse be out to cause furnace not to go on?
Yes, a blown fuse can cause your furnace to not turn on. Check the breaker box and see if any of them have tripped.
What is the purpose of the draft diverter on a gas furnace?
It protects the Pilot Light from being blown out
What is the purpose of the draft diverted on a gas furnace?
It protects the Pilot Light from being blown out
What is the purpose of a draft diverter on a gas furnace?
It protects the Pilot Light from being blown out
How Do You Know If a Fuse is Blown In The Furnace?
In the event that you are discussing a wire free close by the circuit might look great with the visual test then, at that point, still coherence/ohmmeter test is required. Read More.. universalhc.ca/how-do-you-know-if-a-fuse-is-blown-in-the-furnace/
Describe how glass is prepared?
Glass is heated in a furnace until it begins to flow. It can then be blown or molded into shape.
