you need to get the eka code and when you get it if it is "2468" for example change it by adding 1 to the second number and the fourth, so this one would now read "2569". hope this helps
To disable the immobilizer on a Rover Mini, you typically need to locate the immobilizer unit, which is often found under the dashboard or near the ignition system. Disconnecting the battery may reset the system, but this can vary depending on the model year. It's important to consult the vehicle's manual for specific instructions or seek assistance from a professional mechanic, as tampering with the immobilizer can lead to security issues or damage to the vehicle's electrical system. Always ensure that you comply with local laws regarding vehicle modifications.
you should have a 4 digit code that came with the car to remove this if your remote fob ain't working, if u not got code your local rover mg dealer will sell u one around £10 if UK spec car if not then u will need car alarm and immobilizer reprogrammed. this cost me £118 to get done because my car was registered in Ireland.
Hi You will need to contact a rover dealer who will supply you with an eku code to over ride the immobiliser....my sons costs £15
Call your local Land Rover dealership...they will give you a code.
On my 1997 Discovery trying to unlock any door other than the driver's door sets off the security alarm, so I would not count on unlocking all doors from the rear door.
Not enough information.
the code for my stereo in my rover 414i is 0362 hope this helps
Get in touch with a Rover dealer, tell them the problem, they can find out the code for your lock on the door. That way you will not need your fob to open the doors or immobilise it.
You Can not Remove it at at all coz its plugged with the computer system in the Range Rover, OR you can chand and make the computer deny the system by using the SOFTWARE
clutch & pressure plate were replaced remote was changed engine turns good but car wont fire, power reaches coil but does not reach plug leads coil was replaced new same issue car wont start, remote seem to be working good! unlock with key engine does not turn use remote engine turns good! can you help please?
i have the security code number but it has a zero as well as a number eight in it
you can't. simple as that. but if i'm taking you up right and you are genuinely having problems with the immobiliser then i'd reccommend you use a second and last higher digit to sort the problem out for good. just say your code is 3545 don't enter it, but instead enter 3646 and you should here a click from the drivers side engine. thats it. it worked for me and i never had a problem since. by the way if you don't know the original keycode then you won't be able to up the second and last digit accordingly so will not work. hope this helps.