answersLogoWhite

0

What else can I help you with?

Related Questions

How do you connect mounting brackets to fender on a 1976 fxe?

The brackets screw to the fender through holes in the fender and to tabs on the fork legs.


What is the butt end of a hinge?

The butt end of a hinge is the part that attaches to the stationary frame or door jamb. It typically has screw holes for mounting.


What are mounting disks for snowboard bindings?

mounting disks are the disks on the inside of the binding that have holes to screw into the board. they come with the bindings you buy, however replacement disks can be found online. they also control the angle at which you set your foot.


When i bought new front rotors for my 2001 ford windstar the old ones have 3 holes to screw on the new ones dont do these holes need to be there or can you just go without?

You can do without the mounting holes in the replacement rotors.See "Related Questions" below for more


How do you install your safe into a 4 inch thick stud wall?

If it is a safe designed to go in a wall, it should fit between the studs and have mounting holes in the sides. Just screw through the holes into the studs on each side.


How can I effectively cover screw holes in wood for a seamless finish?

To effectively cover screw holes in wood for a seamless finish, you can use wood filler or putty that matches the color of the wood. Fill the hole with the filler, let it dry, sand it down until smooth, and then finish with a coat of paint or stain for a seamless look.


How do I properly screw on a tub overflow cover?

To properly screw on a tub overflow cover, first remove the old cover if necessary. Then, align the new cover over the overflow opening and insert the screws into the designated holes. Use a screwdriver to tighten the screws securely, making sure the cover is flush against the tub surface.


What is the recommended 8 screw size for securing the mounting bracket to the wall?

The recommended screw size for securing the mounting bracket to the wall is 8.


What is the standard tripod mounting screw size for most cameras?

The standard tripod mounting screw size for most cameras is 1/4 inch.


How can I effectively use wood filler to cover up screw holes in my project?

To effectively use wood filler to cover up screw holes in your project, first ensure the holes are clean and dry. Apply the wood filler generously to the hole, slightly overfilling it. Allow the filler to dry completely before sanding it down to be level with the surface. Finish by painting or staining the area to match the rest of the project.


What is the standard 10 screw hole size for mounting hardware?

The standard 10 screw hole size for mounting hardware is 3/16 inch in diameter.


What tool is commonly used for making screw holes in wood?

A drill is commonly used for making screw holes in wood.