Ethernet hardware addresses are 48 bits, expressed as 12 hexadecimal
digits (0-9, plus A-F, capitalized). These 12 hex digits consist of
the first/left 6 digits (which should match the vendor of the Ethernet
interface) and the last/right 6 digits which specify the interface serial number for that interface vendor.
These high-order 3 octets (6 hex digits) are also known as the
Organizationally Unique Identifier or OUI.
A list of ethernet vendors are at : <URL:http://www.cavebear.com/CaveBear/Ethernet/vendor.html>
<URL:ftp://ftp.cavebear.com/pub/Ethernet-codes>
<URL:gopher://ftp.cavebear.com/00/pub/Ethernet-codes>
From a command prompt type: ipconfig /all It will list the adapter's Ethernet address as "Physical Address". It will be 6 pairs of hex values with dashes in between.
The low level addressing scheme used on Ethernet. The 48-bit destination Ethernet address in a packet is compared with the receiving node's Ethernet address.
How many bits are there in a data link layer ethernet address?
A MAC address is unique to your ethernet card. MAC addresses are used within an Ethernet network to uniquely identify the source and destination of Ethernet frames. ARP (Address Resolution Protocol) is used on IP networks to map IP addresses to MAC addresses within an Ethernet network.
mac address only
Mac address only!
The "MAC" address of your computer is built into the Ethernet board.
Connect a CAT5 ethernet cable that runs from the Wii to an available Ethernet jack or to your home router and enter your IP Address into the Wii's settings.
One computer must have unique MAC addresses for each Ethernet adapter (ideally each Ethernet adapter in existence has a unique MAC address but there are some that allow manual setting of the MAC, so duplicates can exist.) If you have not changed anything from the factory settings then each network card will have a unique address!
Ethernet
Run "ipconfig".. If your Ethernet will be active it will show you the current IP address of NIC..
It's represented in HEX format.