vtech is having 2 cams one for low end torque then switches to the other for high end torque vtech is having 2 cams one for low end torque then switches to the other for high end torque
Diesel engines have much more torque at low rpm.
load is heavier so starting torque is requiredAnswerBecause the same current is passing through both the armature and field windings, the torque is proportional to the squareof the current. Since the starting current is alway high (no back emf), the torque will be very high indeed.
torque/weight ratio of an instrument indicates sensitivity.if a pointer is having less weight, it will be having high torque/weight ratio so that even for a very small deflection pointer starts moving and indicates measured value.
Good
Naturally aspirated - 145 net horsepower. Turbocharged - 180 net horsepower. They both have fairly low horsepower engines by modern standards, but they achieve decent performance by having extremely high torque instead.
No... It is NOT good for you. I hope noboby that you know has high-blood pressure... -Koalabear06
the torque is that is where all your power is it doesnt matter how fast the drill spins if it has no torque. That's why impact drills are so good cause they have alot of torque but don't spin as fast. But your should get a drill with alot of torque and a high number of amps per hour
Higher torque is better - look for 6.75 and above in torque.
If you are having trouble cranking over a warm motor, it is usually in the electrical system. The selenoids get hot. Especially if the headers wrap around it. A strong battery, good wiring, and a high torque starter, is a must.
yes both are high numbers, but the 143 diastolic is VERY high... almost twice as high as it should be... this is the realm we call in the clinic as stroking out... and yes as in having a stroke. go see a DR NOW!
It's how far the piston travels from its top position to its bottom position as the crank turns. Long stroke is usually good for high torque and short stroke is good for high revs.