0
NUMBER 975
LHP PUMP DRIVE BELT REPLACEMENT
P/N 1-653163(44/48) 1-653416(52)
PAGE 13, ITEM 48 IN LAZER HP 220,000 & HIGHER PARTS MANUAL
PAGE 11, ITEM 48 IN LAZER HP 160,000 & HIGHER PARTS MANUAL
TOOLS REQUIRED: ½", 9/16" Box/Open End Wrenches
3/8" Ratchet with ½" and 9/16" Sockets
1. Remove the ignition key, engage the brake, and drop the deck to its lowest setting.
2. Remove the deck drive belt from around the clutch. Place the belt between the deck and the drive wheel to keep it out of the way. See Figure 2, Reference #3.
3. Disconnect the clutch from the connector.
4. Remove the clutch strap from the engine deck. See Figure 1, Reference #1.
5. Push on the edge of the pump idler to take up the spring pressure, and then remove the pump belt from the sheaves. See arrow Figure 1.
6. Loosen the idler arm bolt enough to slide the belt over the pulley. Hold the nyloc nut on top of the engine deck by reaching up between the engine deck and the cutting deck with a 9/16" box end wrench. To ease reassembly, leave wrench on the nut when done. See Figure 1, Reference #2.
7. Install and route the new belt, leaving it off of one of the pump pulleys. See Figure 2.
8. Before tightening the idler arm bolt, ensure that the idler spring is not sitting on top of the right pump sheave as seen in Figure 2. Place the spring so it sets in the groove of the pulley where the belt runs.
9. Push on the edge of the idler arm to take up the spring pressure while routing the pump belt around the remaining pump pulley. Slowly release the idler, and ensure that the belt has remained in place around the other sheaves.
10. Reassemble in reverse order starting at step 4.
What else can I help you with?
How much horsepower does a 250cc engine equal?
On a exmark lazer z e-series 250 cc motor
Can you change the batteries from a shocking lazer pen?
I guess so
Which type of mouse uses a laser to detect the mouses movement?
A lazer mouse.
How can you see a beam of light from a lazer?
you can see the beam a lazer by shining the lazer at a wall with the lights turned off then spraying something of a mist over the lazer beam.
When was Major Lazer created?
Major Lazer was created in 2009.
How do you make lazer-beam on doodle god?
Radiowave + Fire = Lazer
How long should it take to change the thermostat on a 2000 Chevy B lazer?
Less than a half hour.
Where is ima firin ma lazer from?
ima firin ma lazer is from the youtube comedian Dominic Fear on his hit series The Lazer Collection.
When was Radio Lazer created?
Radio Lazer was created on 1991-08-05.
When did Lazer Tag Academy end?
Lazer Tag Academy ended in 1987.
When was Lazer Tag Academy created?
Lazer Tag Academy was created in 1986.
When was Lazer Beam created?
Lazer Beam was created on 2005-08-15.
