0
http://www.uniden.com/pdf/BC92XLTom.pdf
The manual knows all.
Straight From the Manuel:
Storing Known Frequencies
Into Channels
1. Press Hold. Then enter the channel number where you want to store a frequency, then press Func and Pgm. The channel number appears.
2. Use the number keys and to enter the frequency (including the decimal point) you want to store.
3. Press E to store the frequency into the channel. Notes:
• If you entered an invalid frequency in Step 2, Error appears and the scanner beeps three times. Enter a valid frequency.
• The scanner automatically rounds the entered number to the nearest valid frequency. For example, if you enter 151.473 (MHz), your scanner accepts it as 151.475.
• When you enter a frequency into a channel, the scanner automatically turns on the delay function and DLY appears. When delay is turned on, the scanner automatically pauses scanning
2 seconds after the end of a transmission before scanning proceeds to the next channel. To turn the function off or on, press Func + Dly.
• If you enter a frequency that has already been entered elsewhere, the scanner sounds an error tone and displays the channel that was duplicated. If you entered the frequency by mis- take, press then enter the correct frequency. To enter the frequency anyway, press E to accept.
4. To program the next channel in sequence, press E then repeat Steps 2 and 3.
What else can I help you with?
How do you program a regency scanner model R4020?
Programming scanner r1040
How do you program a uniden bearcat BC 370 CRS scanner?
easy to program
Is scanner a hardware or software?
A scanner is both hardware and software, the device itself is hardware (all devices are hardware) but the driver(a program) that runs it is software.
How do you program remote for Chevy colbalt?
You need a gm scanner to program a factory gm remote fobs.
What program do shonen jump artists use?
Pen and paper and scanner.
What is the purpose of a vulnerability scanner?
A network vulnerability scanner is a program written to find vulnerabilities in other programs run on either a computer or the network. There are different types of vulnerability scanners based on what the scanner is scanning.
How do you retrive fault codes from a 3000GT?
A automotive scanner with an Asian program is required.
What scanner is needed to program a keyless entry remote?
The car is the scanner. Depending on the make and model a new key less FOB can be programmed by pushingcertain buttons on the car in a certain sequence. What year make and model are you trying to program.
How do i program my radio shack pro 2017 for monterey county in California?
how do i program my radio shack pro 2017 scanner where is my answers
How do you program a pro 96 radioshack digital scanner?
here's the way i do it .... press man 0 program enetr freq number
How do you set the timing on a 1995 3.8 Ford Thunderbird?
denomanater scanner can program your timing
How do you program a Uden Bearcat 30channel10 Band Radio scanner?
To program a Uden Bearcat 30 Channel 10 Band Radio scanner, first turn on the scanner and select the channel you want to program. Press the "Manual" button to access the channel, then press the "Program" button. Enter the desired frequency using the number keys, and confirm by pressing "Enter." Repeat this process for additional channels, and be sure to save your settings before exiting programming mode.
