To reset the computer box (ECU) of a 1988 Polo Classic, first disconnect the battery by removing the negative terminal for about 10-15 minutes. This will clear any stored error codes and reset the ECU. After reconnecting the battery, start the vehicle and allow it to idle for a few minutes to let the ECU recalibrate. If issues persist, consider checking for fault codes or other electrical problems.
try to disconnect battery for 30 seconds
no you don't need to reset the computer. but it is always a good idea to reset it when replacing any censors. just unhook the battery cable( negative) for 30 seconds then put it back on and drive 50-75 miles to reset the computer.
To reset the computer on a 1988 Corvette, you can disconnect the battery by removing the negative terminal for about 10-15 minutes. This will clear any stored trouble codes and reset the engine control unit (ECU). After reconnecting the battery, you may need to drive the car for a short distance to allow the ECU to relearn optimal settings. Always check the owner's manual for specific instructions and precautions.
Coors Classic ended in 1988.
Classic Volkswagens was created in 1988.
undo battery cables from battery and hold posotive and negative together for 5 minutes or so
Let me know the no. We can help u find it
Classic Concentration - 1987 - 1988-07-14 was released on: USA:14 July 1988
Disconnect the battery for 5 minutes. This should reset the light. It will however come right back on unless you have found and repaired the problem that caused the computer to set the light in the first place.
yes
Classic Gold GEM was created on 1988-10-04.
GM vehicles do not have reset switches.GM vehicles do not have reset switches.