0
More rpm means more speed, but the speed is also related to the diameter of the rotating object. The exact formula is: speed = angular speed x radius (assuming compatible units are used: for example, speed in meters/second, angular speed in expressed in radians/second, radius in meters).
What else can I help you with?
Is the rpm sensor same as speed sensor?
The RPM sensor and speed sensor serve different purposes, though they can sometimes be related. The RPM sensor measures the rotational speed of an engine or component, typically expressed in revolutions per minute (RPM). In contrast, a speed sensor measures the vehicle's speed, often in miles per hour or kilometers per hour. While both sensors provide vital information for vehicle performance, they are distinct in their specific functions.
Is Controllable Pitch Propeller rpm different than its ME rpm on-board ship?
Yes, the controllable pitch propeller (CPP) rpm is typically different from the main engine (ME) rpm on a ship. The main engine rpm refers to the rotational speed of the engine itself, while the CPP rpm is influenced by the pitch angle of the blades, which can be adjusted to optimize thrust and efficiency. This allows the ship to maintain a desired speed through the water without needing to change the engine speed significantly. Therefore, while they are related, they do not necessarily match.
What is hdd speed?
HDD RPM speed ?
Why is RPM speed so important to the life of a compressor?
Why is RPM (speed) so important to the life of a compressor
What are the normal RPM 1994 Dodge Ram 1500?
Idle speed will vary from 600-1000 rpm.Idle speed will vary from 600-1000 rpm.
What is the normal RPM for 1 ton dodge dually 2007?
Idle speed could be 550-900 rpmIdle speed could be 550-900 rpm
How is the speed of a piston is determined?
The speed of a piston in an engine is determined by the engine's RPM (revolutions per minute) and the stroke length of the piston. The speed can be calculated using the formula: speed = (2 * pi * RPM * stroke length) / 60. Increasing the RPM or stroke length will increase the speed of the piston.
Hard disk has a rotation speed of 7200RPM then the latency time is?
it depends on more then rotational speed. The Rotational speed and latency time is related as follows: Latency time = (1/((Rotational Speed in RPM)/60)) * 0.5 * 1000 milli seconds
What is the relation between number of poles and rpm?
The number of poles in an electric motor is inversely related to its speed, measured in revolutions per minute (RPM). Specifically, the synchronous speed (RPM) of a motor can be calculated using the formula: RPM = (120 × frequency) / number of poles. This means that as the number of poles increases, the RPM decreases for a given frequency, and vice versa. Thus, motors with more poles typically operate at lower speeds compared to those with fewer poles.
A typical RPM speed for a PC hard drive?
7200 rpm is quite common.
What calculated speed of a four-pole split-phase motor is 1800 RPM. However if you measure the shaft speed you will find it to be 1725 RPM. What causes this loss of rotational speed?
The loss of rotational speed is due to slip in the motor. Slip is a natural characteristic of induction motors and is necessary for torque production. The difference between the synchronous speed (1800 RPM) and actual shaft speed (1725 RPM) represents the slip in the motor.
What is the rpm for the speed of sound?
The speed of sound is approximately 343 meters per second (at standard conditions). There is no direct conversion from speed of sound to rpm (revolutions per minute), as rpm is a measure of rotational speed, while the speed of sound is a measure of how quickly sound waves travel through a medium like air.
