Most LANs use UTP cable, category 5 or better.
No. There's Coax, there's Cat 3, Cat 5 and Cat 6, then there's fiber.
Any new installation will not use cat 3 cable; it is rated at only 10 Mbps and most LANs will run at least 100 Mbps, if not higher.
Either Cat 5 or 5e is most common at this point, although Cat 6 is becoming more prevalent.
The Cat Who Ate Danish Modern was created in 1967-06.
The modern Ethernet cable is a Category 5 UTP cable, with an RJ 45 connector.
electrical wiring
there aren't many answer for this because they are both cats for a higher cat it can go high for a lower it can't go like the higher one and then the opposite.
Cat 3 and Cat 5 cabling are both used for networking local area networks (LANs). They primarily differ in transmission speed and capacity,
Cat 3 and Cat 5 cabling are both used for networking local area networks (LANs). They primarily differ in transmission speed and capacity,
You can find the ECM wiring diagram for a Cat C15 engine in the service manual provided by Caterpillar. This manual is typically available for purchase from authorized Caterpillar dealers or through their website. Additionally, you may be able to find the wiring diagram in online forums or technical websites specializing in heavy equipment repair.
The bigest modern cat is the tiger, this can be 1220mm at the shoulder.
CAT 5/CAT 6 with RJ-45 connectors