RJ11 and RJ45 are the names for the terminators at the ends of the cables.
RJ11 is the 2 pair (4 wire) terminator used for telephones.
RJ45 is the 4 pair (8 wire) terminator used for ethernet cable.
I am sure that phone jacks are RJ-11 not the larger RJ=45.
There are RJ-11, RJ-12, and RJ-45 connectors. RJ-11 is typically used for telephone lines, while RJ-45 is used for NICs.
You can't using telephone cables. Telephone cables use 4 wires, but none of the wires are twisted, so there will be problems with crosstalk. Also, telephone cables use an incorrect connector (RJ-11) for a NIC card in a PC, which needs RJ-45 connectors.
It is on the end of Cat 6 (ethernet) cables.
Cat5 cable is the standard cable for computer networking. The "RJ" in RJ15 stands for registered jack. This is the part at the end of a cable that can be used to connect them to computers, phones, etc.
RJ stands for registered jack. There are a no. of RJ's that we use for e.g., RJ-9 ,RJ-11 RJ-12, RJ-45, RJ-48 etc
Power rj 45 rj 11
A RJ45 can be defined as a telecommunications connector standard for telephone cables. It can also be defined as a connector for computer network (Ethernet) cables.
rollover cables
RJ45 Telecommunications - a connector standard for telephone cables, RJ45 cables are also used as a connector for a computer network by way of connecting to the internet.
You use a Rj-45 connector with twisted-pair cabling in an Ethernet LAN. Rj-45 is a connector with a 4 5 wiring sequence.
Differences between RJ-11 and RJ-45: • RJ-11 (connectors) have positions for 6 wires (3 pairs), used primarily used for voice transmission over typically 2 ranging up to 6 of the wires. • RJ-45 has 8 wires (4 twisted pairs), primarily used for data transmission over 4 to 8 wires. • Connectors are physically different sizes. That said, they have many similarities as well. Some you may not have thought of: • RJ-11 and RJ-45 both have pin spacing that is identical. This is by design. • RJ-11 and RJ-45 both have connectors of identical height. • RJ-11 and RJ-45 both use the same shape and size centralized plastic locking pin. Thus, the only sfdifference being RJ-45 allows for 2 extra pins and is a slight bit wider. So In a pinch, an RJ-11/14 6 wire cable can be used to connect two RJ-45 devices provided that that RJ-11 cable has all four or six wires and the RJ-45 socketed devices are only 10 or 100-base-T (sub gigabit) devices as they only use 4 wires. Gigabit devices require use of all 8 wires so it doesn't work for 1000-base-T devices. Also, if the RJ-11 cable is flat-wire (not twisted pair UTP) then the run will have to be very short due to noise considerations. This makes it harder to achieve full speed on 100 Megabit class connections.