6448 megabytes, or 6.4 gigabytes. Less capacity than most USB thumb drives these days. 12/15/2011
Hard drives do not require drivers.
The Quantum Fireball EX came in a range of sizes in multiples of 3.2 depending on the number of platters. The smallest was 3.2gb, and the largest was 12.7gb with four platters.
You do the proper research and stop trying to get people to do your homework for you.
The Quantum Fireball 3.5 Hard Drive typically features jumper settings for configuring the drive as a master, slave, or cable select. The specific jumper configuration can usually be found on a label on the drive itself or in the user manual. Generally, to set the drive as a master, you would place the jumper on the designated pins for the master configuration, while for slave, it would go on the slave pins. Always ensure to consult the specific documentation for your model for accurate settings.
Sure as long as you have a molex (white peripheral) power connector and an extra IDE connection available you should be good to go. Although these old fireball series seem to be notorious for degrading magnetic sectors after time.
No. Hard drives do not need specific drivers. Instructions are sent to them via the disk controller, which most operating systems should have a driver for.
Yes, the Quantum Tape Ultrium Drive is very easy to install. You just connect the drive to your computer using a 68-pin Ultra160 SCSI cable.
a hard drive failure is when your hard drive stops working...
a hard drive is called "disque dur" in French.
* Hard disk drive * Hard drive * HDD
If the Hard drive is IDE (40 pins on the back) you would configure the primary hard drive as Master and secondary hard drive as Slave using the jumpers on the back of the hard drive.
It is the same as a laptop hard drive