If you need a key code you will needs to contact your local dealer or a locksmith.
I'm not sure what vehicle you are working on, but in many chrysler products you can cycle the key to run ( not start ) 3 times and leave it on run and the stored codes will flash in the odometer
That comes on after cycling the key three times to see any trouble codes. Done, is either end of codes, or no codes present.That comes on after cycling the key three times to see any trouble codes. Done, is either end of codes, or no codes present.
On, off, on, off, on and it should flash codes.
On certain Chrysler products P0201-p0208 can be caused by a failed TPS.
Chrysler products do not have kill switches.Chrysler products do not have kill switches.
Most Chrysler dealers have key machines. Your key most likely has a "chip" that requires programming.
Chrysler does not have reset switches. You need to check for trouble codes with a scan tool.Chrysler does not have reset switches. You need to check for trouble codes with a scan tool.
On a Chrysler vehicle with sentry key (chip key), you just have to put the key in the ignition and turn it on.On a Chrysler vehicle with sentry key (chip key), you just have to put the key in the ignition and turn it on.
With a scan tool.
A key code refers to a series of alphanumeric characters that are usually used by the locksmiths to create a key. There are basically two types of the key codes the biting codes and the blind codes.
how much is a replacement key for a Chrysler Town and Country cost.
That comes up when you cycle the key on,off,on,off,on and it does a self test. "done" means that there are no trouble codes found.