0
What command would be used to duplicate the entire diskette While running DOS on a PC?
Disk copy
DISKCOPY [d:] [d:][/1][/V][/M]
where;
/1 - Copies only the first side of the diskette, even if the target diskette is double sided.
/V - Verifies that the source data was copied correctly onto the destination drive. Selecting this option will slow down the copying process.
/M - Forces DISKCOPY to use only conventional memory for interim storage during the copy procedure. Normally, DISKCOPY uses the hard disk for this purpose.
After copying, the program will display
Disk copy OK
Copy another (Y/N) ?__ - reply Y for yes or N for no and the programme will close.
This sequance will need to be run under the CMD command when using a windos programme and needing to start the command line editor
What else can I help you with?
While running DOS on a PC which command would be used to duplicate the entire diskette?
diskcopy
How do you paste in vi?
You use the 'yank' and 'put' commands. You 'yank' the lines into a buffer (named a - z) and then go to the place where you want to paste or duplicate them, and use the 'put' command to insert them. You can also read entire files or portions of files with the 'r' command to paste contents into other files.
What is the system duplication tool used to duplicate an entire hard drive?
SYSPREP
When at Command Quarters the CO musters the entire command in a single formation?
true
What is the best way to remove duplicate iTunes files?
The best way to remove duplicate iTunes files is to manually delete them on the computer. This entails going through an entire playlist and manually deleting each duplicate entry.
Used to hide an entire worksheet?
hide command
Who is responsible for enforcing policy in the unit?
The entire chain of command.
What is command you in Hebrew?
to command = tseevah. But in order to add "you", we would need to see the entire sentence, because it depends on the context.
What is the current running the entire circuit?
3
What command would the network administrator apply to a router that is running OSPF to advertise the entire range of addresses included in 172.16.0.0 19 in area 0?
**R1(config-router)# network 172.16.0.0 0.0.31.255 area 0
What is the best situation where an oligopoly exists?
A small number of producers command nearly the entire market for a certain good of service
Define an entire new range as a data table?
data table command
