0
What else can I help you with?
Older hard drives use what kind of conductor IDE conductor ribbon cable?
The correct answer is....80-conductor IDE ribbon cable.
What connects with a ribbon cable?
A 34-pin ribbon cable will connect a floppy drive.A 40 (or 80) conductor ribbon cable is for (E)IDE devices.Other ribbon cables may be used (80 conductor for SCSI, and in older systems, MFM and RLL Hard drives).A smaller ribbon cable (10 conductors) may be used for USB Headers.I think that covers most of them.
How many conductors are there in an ATA 66 ribbon cable?
80
What are three types of ribbon cables you might find inside a PC?
3 types of ribbon cables found in a PC are, a 34-pin floppy drive cable with twist, a 40-pin IDE cable with 40 wires, and a 40-pin IDE cable with 80 fine wires(80 conductor cable)A floppy drive cable, an IDE cable, and a CD or DVD drive cable
How does the Hard Drive connect to the mother board?
Hard Drives connect to the motherboard one of two ways. Either using a 40-wire/40-pin HDD ribbon cable, or an 80-wire/40-pin HDD ribbon cable. HDD stands for Hard Drive Disk.
What do UltraDMA66 and higher require?
UltraDMA/66 requires a special ribbon cable with extra wires (80 wire) to cut down on crosstalk
Which disk drive standards uses an 80-conductor cable?
The drive interface that uses an 80-conductor ribbon cable is IDE. IDE stands for Integrated Drive Electronics, an interface commonly used to connect hard disks and optical drives to computers.
How can you tell the difference between a floppy ribbon and an IDE ribbon?
Floppy Ribbon : The floppy cable has 34 wires. There are normally five connectors on the floppy interface cable, although sometimes there are only three. These are grouped into three "sets"; a single connector plus two pairs of two each (for a standard, five-connector cable) or three single connectors. IDE Ribbon : IDE cables consist of either 40 individual wires or 80 individual wires. Ultra ATA/66 or later devices need the 80 wire cables to operate efficiently. Most of these wires are used to transfer data between the motherboard and the drives.
What are two types of PATA data cables?
Under parallel ata, two types of ribbon cable are used. The 80-conductor ide cable has 40 pins and 80 wires Forty wires are used for communication and data, and an additional 40 ground wires reduce crosstalk on the cable. An older 40-conducror cable has 40 wires and 40 pins. the two types of cables are PATA and IDE cables which come in a 80-conductor IDE cable and a 40-conductor cable
How many types of Ribbon Cables might a system have?
A 40 or an 80
How many pins and wires do a 80 conductor IDE cable has?
40, 80
What is the drive nearest motherboard when using an 80-conductor cable-select cable?
Master.
