answersLogoWhite

0

it allows you to create a permanent entry in your cache

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What command is used to view the ARP table?

To view the ARP table, you can use the command arp -a in the command prompt on Windows or arp on Unix/Linux systems. This command displays the IP addresses and their corresponding MAC addresses that the device has recently communicated with. Additionally, on Linux, you can also use ip neigh to view the ARP table.


What command allows you to view entries in the ARP table of a Cisco router?

show ip arp


How do you close from command prompt?

Type exit to close the Command Prompt window, or click the red X in the corner. To shut down your computer, type shutdown -s


How do you exit a prompt command?

Use "prompt $p$g" command.


What will happen if you execute the following command arp and ndashd?

The command arp -d is used to delete an entry from the ARP (Address Resolution Protocol) cache on a networked device. Executing this command will remove the specified IP-to-MAC address mapping, which may disrupt communication with that device until the entry is rebuilt through ARP requests. If no specific entry is provided, it may lead to the deletion of all ARP entries, necessitating the re-establishment of connections. However, the actual output and behavior can depend on the specific operating system and its implementation of the ARP command.


Command prompt doesn't show if my PC is running in safe mode with command prompt?

Safe mode with command prompt option is totally depends on DOS shell, hence there is no need for separate command prompt..


How do you do next line in command prompt?

when using command prompt, after you give it a command, press the enter button. Command prompt will then carry out the task and will automatically go to the next line.


What end-system command would you use to delete a specific entry from an ARP table?

arp -d ip-address


What do you know about PROMPT command in MS-DOS?

PROMPT command is an internal command, which is used to change the MS-DOS prompt. Through, the system displays the prompt bu default, when you start the computer.


How do you get the IPA of a computer from the command prompt?

In command prompt write "ipconfig/all" command and then press [enter]. And see the IPv4 Address section in the commend prompt.


What is the Command Prompt?

when you are in cmd command prompt "type" help and you will see all the codes


What command clears all previous entries in the command prompt window?

To clear the Command Prompt window, enter CLS