answersLogoWhite

0

I am person in need of a awnser " What happens when oil hits a toucch screen I am person in need of a awnser " What happens when oil hits a toucch screen

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What happens to cooking oil in the sun?

nothing happens only it gets hot that you may not want to touch at all. but thing get in the oil, the oil can start to smell and no way you want to get near that or touch because it will smell horrible?


How do you reset the touch screen display on a Toyota Highlander?

how to reset display screen after changing oil at 15000 miles. this is on a 2008 highlander.


How did the boat oil get out?

Usually it happens when an oil carrying boat hits a reef of in some cases an iceberg and tears or rips the hull open, when this happens the oil spills into the ocean.


What is an iPod touch made of?

An Ipod touch is made of 3 ply sheet glass. the frame is made of lightweight metal for comfort and reliability. The touch screen is activated by the heat and special oil in your hands.


What is an oil screen?

The oil screen is attached to the bottom of the pickup tube of the oil pump in the oil pan.


What happens when engine oil goes in screen wash?

If engine oil goes into the screen wash, or windshield washer fluid, the reservoir and hoses become full of greasy gunk. This will clog the hoses and reservoir. Remove and clean immediately.


What causes low oil pressure after 20 minutes of driving?

Could be oil screen on pump with sludge build up after a lot of miles if screen is clear relace oil pump if your engine does not knock mine was a dirty pump oil screen


How do you reset oil change light on a 92 Oldsmobile toronado?

Check inside the passenger compartment under glove box - there should be a small hole (about the size of a pencil) there may be a switch insideWith key on (engine not running) depress this switch with a pen or pencilIf so equipped that should resetHow to reset the oil change lightFor a 92, also will work for a 90 or 91, if you have the touch screen you push the INFO button and then select the oil life option and there will be a reset option on the top right of the screen. If you don't have the touch screen then press the ENG DATA button a few times till the oil life is displayed and then press and hold the reset/enter button for 5 seconds while the oil life is displayed and that will reset your change oil light.


What is the Function of oil strainer screen in motorcycle?

The same as the filter in a car engine... to screen out impurities from the oil in case it damages the engine.


Does a xr100 have a oil filter?

No filter just a oil strainer screen.


305 with no oil pressure?

Did you remove oil sending unit and install a oil pressure gauge in it's place and read it so you can rule out the gauge in the dash and sending unit ? If not, then do it. Then if you don't have oil pressure. Remove the oil pan and check the oil pump pick-up screen to see if it is stoped up, if it is replace oil pump and screen. If it's not then replace oil pump and screen anyway.


What is a sump screen I need to change an oil pump on 1993 suburban and I'm not sure what this is?

The oil pump pulls oil up from the bottom of the oil pan and pumps it through the passages in the engine to the bearings and hydraulic lifters (if any). The tube that goes from the bottom of the oil pump into the oil pan is covered with a screen to keep out any potential large "chunks" of anything that got into the engine. The screen is called a sump screen and can usually be cleaned and re-used when the pump is replaced, provided that the screen is still in good shape.