The low level addressing scheme used on Ethernet. The 48-bit destination Ethernet address in a packet is compared with the receiving node's Ethernet address.
Physical and MAC addressing are found in the OSI layer 2?
MAC address is a unique number which is necessary for communication between computers in network. It identifies a source and destination device within a Ethernet network.
There is no difference; Ethernet is Ethernet, regardless of where it is deployed.
10-Mbps Ethernet, 100-Mbps or Fast Ethernet, and 1000-Mbps or Gigabit Ethernet.
form_title=Ethernet Cable form_header=Connect to the internet with an ethernet cable. How many ethernet cables would you need?= {(),1,2,3,4,5,6,7,8,9,10} How long do the cables need to be?=_ Where do you need the ethernet cables?=_
With an ethernet cable. (male)
Ethernet devices are identified by their MAC address, not an IP address. If their were no MAC address incorporated into the device then it is not following the rules define for the ethernet protocol. It would not be an ethernet network adapter or it would be a defective ethernet network adapter. As the LANs are designed for arbitrary network layer protocols, not just IP, so if the adapters are assigned with IP addresses rather than MAC addresses, than it will be difficult for adapters to support other network layers. Even if the adapters use entire network layer addressing schemes, they will need to be reconfigured every time they are powered up. So it is imperative to use neutral MAC address independent of network layer addressing schemes in order to ensure better performance of network.
Ethernet is the most popular networking technology used in LANs. Fast Ethernet is used to refer to any version of Ethernet that meets or surpasses the 100 Mbps transfer speed.
IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...
Arpa encapsulation must be used to enable Ethernet II frame type on your Ethernet.
99 out of 100 times, Ethernet.