Printhead and cartridge are two different things. but for some printers, the printhead is part of the cartridge.
Printhead and cartridge are two different things. but for some printers, the printhead is part of the cartridge.
The inkjet printhead is the part of the printer which the cartridge clips into. These rarely need replacing but if one does require them, they can be purchased from the manufacturer.
To manually clean the printhead nozzles on a Brother DCP-J125 printer, follow these steps: Prepare the Printer: Turn on your Brother DCP-J125 printer and lift the scanner cover to access the printhead area. Make sure the printer is not currently printing or in the middle of any operation. Remove Ink Cartridges: Open the ink cartridge cover by pushing down on the release lever. Carefully remove all the ink cartridges from the printer. Locate Printhead Nozzles: With the ink cartridges removed, you'll be able to see the printhead assembly. Look for the nozzles, which are small holes or slots on the underside of the printhead where the ink comes out. Prepare Cleaning Solution: Create a cleaning solution by mixing distilled water with a small amount of mild liquid detergent or printhead cleaning solution. Use a clean container to mix the solution. Soak Printhead Nozzles: Dip a lint-free cloth or cotton swab into the cleaning solution. Gently dab the cloth or swab onto the printhead nozzles to soak them with the cleaning solution. Avoid rubbing or pressing too hard, as this can damage the printhead. Clean Printhead Nozzles: After soaking the printhead nozzles, use a clean, dry lint-free cloth or cotton swab to gently wipe away any dried ink or debris. Repeat this process until no more ink residue is visible on the cloth or swab. Replace Ink Cartridges: Once you've finished cleaning the printhead nozzles, allow them to dry completely. Then, reinstall the ink cartridges into their respective slots and close the ink cartridge cover securely. Perform Printhead Cleaning: After manually cleaning the printhead nozzles, you may want to run a printhead cleaning cycle using the printer's built-in cleaning utility. Refer to your printer's user manual for instructions on how to perform a printhead cleaning. Test Print: After completing the printhead cleaning process, print a test page to check the print quality. If necessary, repeat the cleaning process or run additional printhead cleaning cycles until the print quality improves. By following these steps, you can manually clean the printhead nozzles on your Brother DCP-J125 printer to help improve print quality and prevent clogs. If you encounter any difficulties or the print quality does not improve after cleaning, consider contacting Brother customer support for further assistance.
A print head is a movable part in the printer where you place your ink cartridges. Sometimes is confused with the cartridges. The print head is no cartridge but the printer compartment where you place your ink so it can apply the ink onto the paper.
US$60.63 from wercan
VH Monitor error for Canon printers. Related to printhead. Usually resolved by replacing printhead, however, problem could also be caused by bad Carriage or Main Board.
Try a Q-Tip with rubbing alcohol.
you can try to find you want in wercan online shop
There are usually two reasons: the red ink nozzle is blocked, try cleaning the printhead. Or the red ink has run out! I don't know the cartridge layout of your printer, so I suggest going on the maker's website for instructions.
I am not sure it may be printhead pins.
The Lexmark 1200 takes a black cartridge and a color cartridge. The black cartridge that the Lexmark 1200 uses is or 16 and 17 cartridge, with the 17 cartridge being the moderate use cartridge. The color cartridge required by the printer is the 26 or 27 cartridge, with the 27 cartridge being a moderate use cartridge as well.
You can buy it on online websites like Amazon, ebay, or others.