answersLogoWhite

0

What else can I help you with?

Related Questions

Will a 5x115mm bolt pattern wheel fit a 5x120mm bolt pattern hub?

no.


What is the Torx bolt size for 97 Cavalier wheel hub?

# 55


Is the 5 lug bolt pattern the same from 1996 to 2010 on dodge ram?

The bolt pattern is the same, but the hub length is different. Newer wheels do not always fit on pre 2002 trucks do to the hub.


Can a non abs front hub interchange with a abs hub on a 2007 HHR?

It will bolt in but the abs light will illuminate and the abs will not function.


How do you check rear hub fluid?

Different vehicles have different rear hub fluid checking/filling system. Normally you have a bolt, you undo the bolt for checking the fluid level, if necessary replenish the level. Newaz.


What is the bolt pattern and center hub size on a 1991 Mazda Miata?

14x10


How do you change a cv axle for your 1990 integra?

loosen axle bolt take outer tie rod bolt off remove from hub take bottom ball joint bolt off seprate from hub and pull out alittle and axle can come out then put it back together


What is the hub diameter of a 2001 4dr Honda accord ex v6?

Hub Diameter--->64.1......bolt pattern---->5 X 114.3


How do you remove crankshaft hub retaining bolt on 1999 BMW 740i and is that bolt left hand thread?

You'll need a special tool to hold the hub behind the bolt. The crank bolt is not left threaded. It is a normal bolt, lefty loosy righty tighty. An impact gun rated at least 300lbs will be required. 600lb impact will spin it right off and is the easiest.


Are the bolt patterns the same for a 1998 Dodge Ram and a 2004 Dodge Ram?

The bolt pattern is the same, but the hub is longer on the 1998 Ram 2wd. The 2004 style wheels may not fit on the 1998.The bolt pattern is the same, but the hub is longer on the 1998 Ram 2wd. The 2004 style wheels may not fit on the 1998.


What is bearing puller?

A bearing puller is a steel tool with a central hub and a threaded bolt hole running through it, containing a large bolt. There are 2-4 arms with clawed ends attached to the hub so they can be placed around a bearing on a shaft. The bolt is then tightened against the shaft, pulling the bearing off.


What is a bearing puller?

A bearing puller is a steel tool with a central hub and a threaded bolt hole running through it, containing a large bolt. There are 2-4 arms with clawed ends attached to the hub so they can be placed around a bearing on a shaft. The bolt is then tightened against the shaft, pulling the bearing off.