0
What else can I help you with?
What is AARH in flange finish?
Acronym: AARH Definition: Arithmetic Average Roughness Height
What 125aarh means on valve?
it is a finish standard of valve flanges
When will the engineer update be released in Team Fortress 2?
When Valve finish it, be patient.
What is the valve of a browning semi automatic shotgun?
Need a detailed description of finish, condition, box, papers, all features and markings.
What is the valve of a army colt 38?
Can't be valued without a detailed description of all features, box, papers, finish, condition, accessories, etc.
What is the valve of Davenport Model 1895?
Provide a detailed description of all markings, features, finish, condition, box, papers, accessories, caliber, barrel length, sights, etc..
How do you properly bleed cooling system on 1996 olds cutlass?
To bleed the cooling system on a 1996 Olds Cutlass, locate the bleed valve, which is on the front of the engine above the water pump. After making sure the cooling system is not under pressure, open the valve by turning it counterclockwise. Fill the radiator with coolant until no air comes out the bleed valve, and a stream of coolant begins to flow from there instead. Tighten the valve and close the system to finish the job.
What is Valve pocketing?
Valve pocketing is when a valve is hammering the valve seat.mostly due to miss adjusted valve spring/wrong valve spring/to strong of a valve spring or valve stem to short.Makes the valve seat deeper.
If the valve face and valve seat do not contact each other evenly after reconditioning?
If the valve face and valve seat do not contact evenly after reconditioning, it can lead to improper sealing, resulting in leaks and loss of compression in the engine. This uneven contact can cause increased wear on both components and may lead to overheating or premature failure. It is essential to ensure proper alignment and surface finish during the reconditioning process to achieve optimal performance. Regular inspection and adjustment may be necessary to maintain effective sealing.
Why line contact between valve face and valve seat?
Line contact between the valve face and valve seat is crucial for ensuring a proper seal within an engine. This minimal contact area helps reduce wear and allows for better sealing under high pressure, preventing leakage of gases. Additionally, line contact aids in maintaining a consistent and stable seating position, which is essential for optimal engine performance and efficiency. Proper alignment and surface finish are vital to achieving this line contact effectively.
What are the types of frogs valve?
tricuspid valve,bicuspid valve and pulmonary valve
What is used to lock a valve spring on a valve?
A valve spring "keeper" or AKA a valve spring "retainer" is used to lock a valve spring to the valve.
