You don't have to reboot the system.
Because Windows could be pretty much destroyed and private information obtained by anyone's access to the Recovery Console.
those files in case deleted that one we can recovery.......
The Windows Recovery Console was featured on Windows 2000, XP and 2003. The user needed to install the Recovery Console from the Windows CD-ROM before being able to use it. This can be accomplished by starting the computer with the Windows CD-ROM in the drive and hitting the "R" key during setup. From there, the Recovery Console will be installed and accessed.
The Recovery Console is computer software to help diagnose and fix system problems. One can either access it from the Windows installation CD or from the PC boot menu and use it to fix any issues.
Access the Recovery Console by first booting from the Windows 2000/XP CD, or the four Windows 2000 setup disks or install the console under the boot loader menu and access it from there. Insert the 1st of the disks and restart the PC. You are directed to insert each of the four disks in turn, and then the Setup screen appears. Type R to select the "To repair a Windows 2000 installation" option, then type C to select the Recovery Console.
The network administor must have physical access to the device to establish a console connection whereas TELNET access can be established form a remote location. However telnet access depend upon a router with network access's, whereas a console connection can be used to access the router regardless of the router's configuration.
To which recovery operation do you refer?
because telnet sucks!!
Access management console
Then tell me your recovery question.
The two recovery tools new to Windows XP that help recover from a failed boot are the Recovery Console and the Last Known Good Configuration. The Recovery Console provides a command-line interface to troubleshoot and repair system issues, allowing users to access system files and execute commands. The Last Known Good Configuration option allows users to start Windows with the last set of driver and registry settings that worked successfully, potentially bypassing issues caused by recent changes.
Inside the floor shift console. Should have an access panel on the right side of console that can be removed to gain access to ECM.