answersLogoWhite

0

The hard drive controllers are SATA, IDE, and EIDE. The hard drive configuration tells the computer what drive controller to use and how to store the information and where to store the information.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What are Hard Drive Configuration and Controllers?

dont knowufeufgueeufheikw,nfiuef


What are Drive controllers?

Drive controllers are certain cricuits that control drives like the hard disk


What are Hard Drive Configuration?

Hard Drive configuration is used to define the Slave and master Hard Drive. When we are attaching more than one hard drive the configuration is used. Configuration is done by jumper setting which is available in back side of hard drive...1st two pins for master hard drive and last pins are slave..


If a hard drive has slave-drive configuration it is probably?

The second drive.....


When installing an IDE hard drive's configuration a master or slave is handled?

the hard drive should be set to master...


What software is used program files do not exist on the hard drive and no configuration data is stored on the hard drive?

Portable Software is used.


What determines if an IDE hard drive will act as a marter or slave im a particular configuration?

Arrangement of Jumper pins on Hard Drive


When What software is used program files do not exist on the hard drive and no configuration data is stored on the hard drive?

Portable Software is used.


What is a hard drive diagnostic program?

Hard drive diagnostic program contains the utility to create a bootable USB flash disk. This hard drive diagnostic program can be used to report problems with hard disk drives on PXI/PXIe embedded controllers.


What do you do after configuring the hard drive?

Either do you install an operating system or create a partition. I don't know what do you mean with configuration of a hard drive. Is it a new one?


IDE and EIDE hard drives are usually set to be in what configuration by default?

Single drive


What are common jumpers setting for a hard drive configuration?

Primary master and secondary master