answersLogoWhite

0

It is nothing but the physical contacts with d IC chip, may be as I/o or O/p.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is microproccesser?

http://en.wikipedia.org/wiki/Microprocessor


What is meant by a dual-port txv?

step motor


What is meant by a dual port TXV?

step motor


What episode of NCIS did the port to port killer case start?

912


Trucking What is meant by the term 'chicken coop'?

Weigh Station or Port of Entry.


Rich Port first meant the city of San Juan but is now the name of the whole island?

Yes. Rich Port translated into Spanish is "Puerto Rico".


Typically via what type of port do PC cameras attach to a system?

USB Port located in the rear of the computer case.


Are lawyers meant to lie?

No. Lawyers are meant to do extensive research on the case and side they are hired for. They are meant to defend their clients to the best of their abilities.


Where DO you specify ip adddress and port number in case of UDP?

UDP is a connection-less protocol, so you'll specify the port (and, in case of multiple local IP addresses, the address) to listen to on the receive side. On the initiator, you specify the destination address and port with every packet.


I can't find the slot to plug in my SD adapter?

Most adapters plug into a USB port, if that is the case then find the standard USB port on your computer, it is a small sideways rectangular port.


What is meant by serial and parallel transmission?

A serial port only allows a single bit of data through at a time. A parallel port allows multiple bits of data through at a time.


How do you change the lube in a Johnson 25hp lower unit?

To change the lower case lube, undo the drain located at the bottom of the case and drain fluid. Above the drain port approx 6" there is another port. Remove that plug as well. Once the case is drained refill it by forcing the fluid into the bottom port. When it starts to come out of the top port it is full. Install drain plugs and you are done. You have to fill from the bottom to avoid any air pockets.