0
What else can I help you with?
Which address does a switch use for implementing port security?
The source MAC address
What address does a switch use for implementing port security?
source mac address
What will be the effect of executing the following command on port F01 switch (config-if) switch port port-security mac-address 00C0.35F0.8301?
Executing the command switch port port-security mac-address 00C0.35F0.8301 on a port (F01) in interface configuration mode enables port security and sets a specific MAC address as the allowed device for that port. This means only the device with the MAC address 00C0.35F0.8301 will be permitted to send traffic through the port. If another device attempts to connect, the switch will either drop the traffic or shut down the port, depending on the configured violation action. This enhances network security by preventing unauthorized access.
When port security is enabled a switch port uses the default violation mode of until specifically configured to use a different violation mode?
Yes, By default port security is disabled on a Cisco switch. If it is enabled the default violation mode is shutdown with a maximum MAC address count of 1. Even if port-security is enabled it will not place a port into the shutdown state until either MAC address sticky or a static MAC address is configured on the port.
What is a valid reason for a switch to deny port access to new devices when port security is?
The denied MAC address are statically configured on the port
Where is American Security Equipment Corp.?
American Security Equipment Corp. is in Carson, California
What is the valid reason for a switch to deny port access to new devices when port security is enabled?
The denied MAC address are statically configured on the port
What city is American Security Equipment Corp. in?
American Security Equipment Corp. is in Carson, California
What state is the American Security Equipment Corp. based?
American Security Equipment Corp. is in Carson, California
What does switchport port-security protect command do?
The switchport port-security protect command is used in Cisco switches to enable port security on a specific switch port. When this command is configured, the port will allow traffic only from MAC addresses that are already learned and stored in the port's memory. If an unauthorized MAC address tries to connect, the switch will drop the traffic from that address, effectively preventing unauthorized access while allowing legitimate traffic through. This security measure helps to mitigate risks associated with MAC flooding and unauthorized devices.
What does PATCO stand for?
port authority transit corp
Can you change port address?
Yes, most protocols have the ability in a configuration file to state which port they will use (as a default),but this can be changed, and is frequently changed for security purposes.
