0
What else can I help you with?
What was the first indication of improper hard drive jumper assignments?
Hard drive is not read nor recognized by the system.
What would be the first sign of a hard drive jumper assignment improperly?
Hard drive is not read nor recognized by the system.
Is there a jumper on the optical drive?
No
What is a hard drive jumper?
It upgrades your hard drive
Will a computer booted that has no jumper on the hard drive?
This question is highly dependent on the specifics of your hard drive. Some hard drives have jumper set ups where theres a setting that has no jumper. If that's your type of hard drive then there should be no issue. Either way the computer should boot regardless of jumper setup. It just may not be able to load the Operating System.
When installing an optical drive for a PATA interface set the jumper on the?
Rear of the drive
What are theQuantum Fireball 3.5 Hard Drive jumper configuration?
The Quantum Fireball 3.5 Hard Drive typically features jumper settings for configuring the drive as a master, slave, or cable select. The specific jumper configuration can usually be found on a label on the drive itself or in the user manual. Generally, to set the drive as a master, you would place the jumper on the designated pins for the master configuration, while for slave, it would go on the slave pins. Always ensure to consult the specific documentation for your model for accurate settings.
What is likely to cause a drive letter assignment to inadvertently change?
installing a new drive
How is installing a PATA drive different from instaling a SATA drive?
I'm pretty sure for a PATA you have to set a jumper.
What is most likely to cause a drive letter assignment to inadvertently change?
installing a new drive
What determines if an IDE hard drive will act as a marter or slave im a particular configuration?
Arrangement of Jumper pins on Hard Drive
When an ide pata CD drive is connected along the same cable as a faster hard drive it is important to set the CD drive to?
set the faster drive to master jumper settings only if it has a working OS on it if not then it wont matter. just remember whichever drive you're using to boot your OS from is the one you have set on master and the second drive should be set to slave jumper settings.
