answersLogoWhite

0

There are three.

1. IDE

2. Sata

3. SCSI

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

For today's hard drives the hard drive controller is on a circuit board on or inside the drive housing?

For today's hard drives, the hard drive controller is firmware on a circuit board on or inside the drive housing.


If a hard drive and DVD drive are connected to the ide port with the same cable should the hard drive be on the end connector?

The hard drive should be on the bottom connector and all you other drives on the top connectors. Thats how mines connected!!!!!!!! :-)


Where to buy Motorola ml900 hard drive connector where to buy?

Where to buy Motorola ml900 hard drive


What does the power connector do on the hard drive disk?

It connects the drive to the system power supply.


Where is the hard drive controller located on the circuit board?

in the back


What does an IDE connector do?

An IDE connector is used to connect a CD-ROM drive or hard drive to a motherboard, with a long and flat ribbon cable.


What should be checked in order when a new IDE hard drive is not recognized?

The SATA connector cable, or whatever connector cable you have from the drive to the motherboard.


What sends a signal to the drive when information stored on the hard drive has been requested?

the controller


Does the red line on the cable go to the inside or outside when connecting a new hard drive to a computer?

The red wire always attaches to pin 1 of both the hard drive and the controller or motherboard. The red line is usually closer to the power connector. However, older hard drives did not follow this convention. There might not even be a specification for this. To be sure, look closely at the hard drive for a distinguishing mark on one end of the connector, such as a "1" or triangle indicating which end the red line should be.


Intel 975x express chipset hard drive connector?

what connector connects to the Intel p65 express


Can a primary hard drive be made to a secondary hard drive?

yes adjust the jumper at the back of the drive. it's a white block. it between the interface connector and power connector. you also want to set it aswell in the bios.


Is there a controller card for ram?

There is a a PCI card that acts as a SATA hard drive. they call it a controller card