0
What else can I help you with?
Does first step in preparing the motherboard to go in the case is to set the jumpers or DIP switches?
Yes.
Is the first step in preparing the motherboard to go in the case is to set the jumpers or dip switches?
Ground yourself.
List three ways that configuration information can be stored on a motherboard?
List three ways in whicn configuration information can be stored in a motherboard
What on the motherboard are small pins that enables you to configure motherboard setting?
jumpers
Why do you think the trend is to store configuration information a motherboard in CMOS setup rather than by using jumper or switches?
Because you can change the settings to the CMOS setup by pressing a key or combination of keys during the boot process, whereas you have to open your PC to change jumpers or switches.
Which are the testing points on motherboard for circuit level troubleshooting?
wire connections for jumpers
A motherboard can retain setup or installation information in different settings of jumpers on the board?
yes
Motherboard retain setup or installation information in different settings of jumpers on the board?
yes!!
Why is configuration information stored in the cmos ram rather than jumpers or switches?
Bc you can access the CMOS during the boot process and manually make changes if needed... whereas you have to open up the PC to adjust jumpers or switches...
Name the three different ways in which you can configure settings on the motherboard?
# CMOS STORED IN ROM BIOS A FLASH ROM MEMORY CHIP USED TO PERMANENTLY STORE INTRUCTIONS THAT CONTROL BASIC HARDWARE FUNCIONS # JUMPERS CAN RETAIN CONFIGURATION SETUP # DIP (DUAL LINE PACKAGE) SWITCH CAN BE USED TO CONFIGURE
Name 10 component that are contained on a motherboard?
processor, chip set, system clock, ROM BIOS, CMOS configuration chip, CMOS bettery, RAM, RAM cache, system bus with expansion slots, Jumpers and DIP switches, ports that are directly on the board, power supply connections.
How can you use harddisk jumpers?
Hard disk jumpers are short conductors that you can use to bypass circuits in a hard drive, or break into the hard drive. They are most commonly used to configure the motherboard when you are not able to boot up the computer.
