0
What else can I help you with?
On what the tab of the printer properties window you can enable and disable bidirectional support for a printer?
Advanced
If you have your printer hooked up to your desktop PC which is hardwired to the Internet how can you make your printer accessible from your Wi Fi?
You need to enable "file and printer sharing" in the windows firewall settings, after that you have to share the printer. Check and write down/remember the computer ip address where the printer has been connected to. After that in your laptop/desktop Start->Run->//ip_address (for instance, \\192.168.11.3). When the window shows up double click on the printer, confirm to install the driver.
You have installed your printer software but the printer is not shown in the printers and faxes window?
....this means that the printer wasn't installed correctly. In windows XP/2000, for a usb printer, you have to install the drivers first. Then, at the prompting of the software, you insert the usb cable so the OS can asign an enumerator to the device. The HP printers are the biggest problem in that they typicaly install alot of other software at the same time. You didn't include the OS or printer type in your question. These are important to know. Sometimes the PC must be rebooted after software/driver installation in order for the changes to take effect.
You have install window xp from window 2000 and after that the installation the internet doesn't work. so you decide to install window xp media edition and it work now you want to unstall the window?
You cannot "uninstall" Windows. You need to format the hard drive and install Windows from scratch. You can do this by booting from the Windows CD (Windows 2000 in your case, I suppose) and following the steps onscreen. The reason that your internet did not work is probably that you neglected to install a driver for your network card or modem. Installing the driver should allow you to use the internet.
How do you install a rear window on a 2000 Ford Ranger?
How do you install a rear sliding window on a 2000 Ford Ranger?
Shom you how to install window motor for1992chevy Camaro?
Show me you how to install window motor for 1992 Chevy camaro
How do you install Warcraft on window?
just put in the CD and install.
How do you install the rear window on a 1993 G-20 infiniti?
how do you install the passenger front window of a 1993 infiniti g20
How do you install a driver side power window on a 1997 Dodge Dakota?
remove door panel, install new window
Which path should the technician use to run the add printer wizard?
in window Xp;click start>Control Panel>printer and faxes>file>Add printer.
How do you install the Kyocera Fs-720 printer driver on Windows 7 64bit?
Install Windows XP mode on Windows 7. Connect your printer. At the taskbar at the top of the XP mode window, click on the USB tab. Select the Kyocera Fs-720 printer. If it asks you if you want to share, click yes. Your printer is now detected by the virtual xp machine. Download the XP Kyocera Fs-720 driver. Install it. Open the document you want to print in the XP mode and print. You cannot print from Windows 7. You have to do so via the xp mode. To print in the future, you will have to always click on the USB tab and share the printer. (This disconnects it from Windows 7 and connects it to the virtual XP mode machine).
How do I install window trim?
To install window trim, measure and cut the trim to fit around the window, then nail or glue it in place. Sand and paint the trim for a finished look.
