0
What else can I help you with?
What info can you gather from issuing commands on a router or switch?
You can get information about ports, settings on each port, routing tables, filtering rules etc.
What three commands are needed to configure EIGRP on the Paris router?
Paris(config)# router eigrp 100 Paris(config-router)# network 192.168.7.0 Paris(config-router)# network 192.168.8.0
What are networking commands?
it starts the routing protocols on interfaces It allows the router to advertise a network
Which set of commands will allow the network administrator to telnet to RouterB and run debug commands?
The router will be unable to ping 192.168.1.2. The router has two interfaces that participate in the RIP process. The router will forward the updates for 192.168.1.0 on interface Serial0/0/1. The router is not originating routes for 172.16.1.0.
What kind of information provides a workstation connected to network?
router
How is the TCP IP configuration information specified by the default router and dns server commands made available?
The TCP/IP information is supplied to any DHCP client on the network connected to the FastEthernet 0/0 interface of R1
What device sends and receives information about the network layer?
Perhaps you mean a router?
What carries the network layer addressing information that can be interpreted by a router?
routable
Implementing Distance-vector routing protocol?
First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.
Immediately after a router completes its boot sequence the network administrator wants to check the routers configuration From privileged EXEC mode what commands can the administ?
AB
What do you call the router on a network that serves as an exit from that network?
stub router.
What prompt can you issue show commands to investigate a Cisco Router?
User enable. router> enable router#
