0
What else can I help you with?
Where is a wireless router connected to a computer or modem?
A wireless router will usually be connected directly to a high speed modem between the modem and any other device. This allows the router to correctly pass internet requests from the local network (computers connected wirelessly or to a standard port) to the ISP (the high speed modem connected to the Internet port). Connecting a wireless router to a computer would be unusual but it could function if connected to the network port on the computer provided the router-computer connection was properly configured. In this case the computer would have to be configured to route.
When implementing a router-on-a-stick what must be configured on the router to ensure connectivity between different VLANs?
Each subinterface should be configured with its own IP address, subnet mask, and unique VLAN assignment.The physical interface of the router must be connected to a trunk link on the adjacent switch.
What organ is between the small and large intestine?
There isn't really any organ between the small and the large intestines, which are directly connected to each other.
What is difference between serial interface and Ethernet interface?
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
When you have two 6 volt batteries in series with load on them what order do you disconnect them safely?
Establish which terminal is connected to ground and disconnect the wire from the terminal. Disconnect the terminal on the other battery that is connected to the load. Finally disconnect the loop between the batteries.
What is difference between USB host and USB otg?
The difference between a USB host and USB OTG is simple. USB host is one device connected directly to the computer. USB OTG (on-the-go) is where a device, be it a cellphone, tablet, or whatnot is connected and used as the host.
Is there a inline fuseable link between alternator and starter on 98 Dodge Neon?
There is not a fusible link between the alternator and starter. There is a regulator on the alternator. The starter is directly connected to the battery, as is the alternator.
What proveds the physical connection between the network and computer?
To get connected to Network Computer must have installed & configured NIC (Network Interface Card). Then connect RJ45 port on your computer to existing Network Switch ports available in the Network with a Cat5 or Cat6 cable.
What is the difference between local printer and network printer?
A local printer is one that is connected directly to an end user's desktop or laptop computer, and is usually used exclusively by that one end user. This is in contrast to a networked printer, which can be accessed and used by multiple people on the same network that the printer is attached to.
Which membrane lining the subdivisions of the ventral body cavity is extremely delicate and is never directly connected to the exterior?
The serous membrane, specifically the parietal layer, lines the subdivisions of the ventral body cavity. It is extremely delicate and is not directly connected to the exterior, serving to reduce friction between organs and the cavity walls.
What is microsegmentation of a LAN switch?
Essentially, any packet transmitted between ports on the switch behave as though the two connected nodes were directly connected as the only two nodes on the network, thus avoiding packet collisions with other nodes.
What is the difference between a series ohmmeter and a shunt ohmmeter?
Basically, your series and shunt ohmmeters differ in circuit configuration. Your series ohmmeter is configured in a way that your "meter" (which has internal resistance) is connected in series to your "measured resistor" and we all know that those TWO resistances will ADD up causing some sort of inaccuracy. While on the other hand, your shunt ohmmeter is configured in a way wherein your "meter" is connected in PARALLEL to your "measured resistor" that will ease-up the inaccuracy but will only measure resistances ranging from 200 Ohms to 400 Ohms (typically and depending on your configuration).
