answersLogoWhite

0

What else can I help you with?

Related Questions

What layer of the IP stack represents data users as well as encodes and controls the dialog.?

Application


What layer of the IP stack represents data users as well as encodes and controls the dialog?

Application


Does the Network layer convert data packets from the Data Link Layer into electrical signals?

NO,IT CONVERTS them into frame


Which layer is responsible for converting data packets from the Data Link layer into electrical signals?

This protocol would be the NIC (Network Interface Card). The NIC takes frames from layer 2 and converts them into electrical siginal's


What is it called if you are using bits and bytes to represent a code?

If you are using bits and bytes to represent a code, it is referred to as binary representation. This method encodes data using two states, typically represented by 0s and 1s, which are the fundamental units of digital information. In computing, this binary system is essential for processing and storing data.


How many hexadecimals must be used for 128 bit WEP encryption?

Each of the 64 hexadecimal characters encodes 4 bits of binary data, so the entire 64 characters is equivalent to 256 binary bits - which is the actual binary key length used by the WiFi WPA pre-shared key (PSK).


Which process converts binary information into patterns of magnetic flux on a hard disks surface?

The process that converts binary information into patterns of magnetic flux on a hard disk's surface is called magnetic recording. This involves encoding binary data (0s and 1s) into magnetic fields, which are created by the read/write head of the hard drive. The head alters the magnetic orientation of tiny regions on the disk's surface, representing the stored data as changes in magnetic flux. When data is read, the changes in magnetic orientation are detected and translated back into binary information.


What is binary data transmitted on?

Binary Data is transmitted on Data Buses.


How does DSU convert binary data pulses it receives from DTE?

the DSU converts the binary data pulses it receives from the DTE to the line encoding format required by the network, withing the computer the one bits are positive voltages, and zero bits are not voltages or low level voltages.


What would you call a device that works with binary data?

Digital Data is data that is stored in binary, and a Digital Device is any device that works with binary data


What is 0 and 1 binary data?

0 and 1 are two integers. They may represent binary digits or binary data but they need not.


What data in computer system?

binary data