0
What else can I help you with?
1996 jeep Cherokee throttle position sensor location?
It is located on the outside of the throttle body in line with the butterfly. Remove the air intake from the throttle body and it will be accessable on the back side of the throttle body. Easier to work on if you remove the throttle body. Easier to clean it too.
How do I address an idle speed that is too high on a 1989 Toyota Camry?
Could be a frozen throttle plate in throttle body - try to free with a screwdriver in throttle throat
Where is the IAT sensor on a 1995 Honda civic sohc vtec?
should be on top of the throttle body. its a two or three wire plug. It is located on the right side of the throttle body (as you are looking at the engine). It is behind the throttle body and it is a 3 wire plug. Don't reach too far down or you will reach a different sensor.
1990 Volvo 740 turbo Accelerator pressure too hard?
Probably throttle body clogge or cable
What is the best way to remove the starter from a 1997 Nissan Altima with automatic transmission?
Take it out from the top. Take out the air box all the way back to the throttle body. Possibly even take out the throttle body. The starter is way under there. Might need to take out the battery too just to get more room to work. Take it out from the top. Take out the air box all the way back to the throttle body. Possibly even take out the throttle body. The starter is way under there. Might need to take out the battery too just to get more room to work.
Why would the throttle on your 2000 Ford Focus be sticking?
the reason the throttle would be sticking on your focus is that it (the actual unit) could be dirty. or the throttle cable could have dirt in its casing. what you need too do is remove the throttle cable and spray engine degreaser in the casing and hang it up too let the dirt and grime drip from it. be sure to use wd-40 to relubricate the cable. now as of the throttle body do the same thing. but use a non abrasive cloth and wipe the unit clean. make sure there is no dirt in any small cracks or crevises.
How does a throttle body spacer works?
Throttle body spacer works by regulating the flow of air into the engine of the vehicle. It allows more air than is required into the system so that the engine does not have to work too hard to correct the combustion chamber.
Where is the intake runner on Mazda 6?
the runner is inside intake there are too solenoids on top and a accutuator on the side were throttle body is
How do you use 'throttle in a sentence?
Found on a headstone:Here lies CharlieUnder the grassHe hit the throttle too hardWhile trying to pass.Please resist the urge to throttle your siblings.
Where is the air intake sensor on a 1996 ford explorer?
In the big rubber air intake tube , not too far from the throttle body
If the idle speed sensor is changed and the tps sensor is too what can cause the car to rev up to 2000 rpm's 2001 sport trac?
Throttle plate stuck in throttle body? Try to free with a screwdriver
How might ear size keep an arctic fox from losing too much body heat?
how might ear size keep an artic fox losing too much body heat
