answersLogoWhite

0

What else can I help you with?

Related Questions

A technician has determined that a computer is failing to boot because of a power supply that is not supplying power to the hard drives What is the correct course of action?

No attempt should be made to repair the power supply. The power supply should be replaced with a power supply of equal or greater wattage.


A technician is installing a new power supply in a computer Which type of power connector should be used to connect to a PATA hard drive?

A technician is installing a new power supply in a computer Which type of power connector should be used to connect to a PATA hard drive?berg mini-molexmolex.20-pin ATX connector


What should a technician do to determine that the plus 5V rail on the power supply is outputting 2.2 Volts?

A voltmeter will show the voltage on the rail and a technician will know how to use one.


Two technicians are building a computer system. Technician A says that the case power switch is used with the AT power supply. Technician B says that wires from the case power switch are connected?

Two technicians are building a computer system. Technician A says that the case power switch is used with the AT power supply. Technician B says that wires from the case power switch are connected to the system board. Which of the following statements is correct? A. Only Technician A is correct. B. Only Technician B is correct. C. Both technicians are correct. D. Neither technician is correct.


How can a power supply be repaired?

A computer's (PC's) power supply is a sealed unit and should be replaced as a whole - It is dangerous to try and repair the inside of that sealed unit (that is why it is sealed).


What type of power supply connector is used to supply power to the floppy drive light remains lit constantly How should the technician attempt to repair the problem?

The drive appears to be a bad one. Why do you need a floppy disc drive anyways?


What power supply should you replace a 175 watt power supply with?

any power supply with at least 175 watts


What are the challenges in power supply repairs?

I'm sure someone can elaborate on this answer but there is a major aspect of safety involved if you are taking a computer power supply apart, that being the large capacitors inside hold a substantial amount of charge that are enough to give you a nasty shock, so you should drain the power from them before you go poking your fingers inside. Of course you would never do it when the power supply was switched on!


Should you wear ESD wrist strap when working on power supply DC output?

Yes. You should wear one whenever you work inside a computer.


What you mean by internal electrical power supply?

its when theres a power supply inside like a power pack so u can carry it around with u


What danger is posed to a technician by opening a power supply even after it has been unplugged for an extended period of the time?

The capacitors in the power supply may still be 'charged' - and give off a powerful shock if touched.


Where is the built in thermal fuse located on a power supply transformer?

the INside